Honda Spree and Elite 50 Forums

I cant figure out why this clutch keeps slipping.......To start with what I have done: The pads were replaced last summer with an aftermarket type so they have maybe 100miles on them by now. These new ones I would think should be way better than the stock cause they are about an inch longer. After ...

Took parts off the non running motor to put on another motor I had lying around. And guess what????? Taking off the fly wheel from the crank and look what was just hanging all loose and jiggly ...

Sorry for not being specific......I was sucking on vacuum line and fuel then started to run down gas line. Like i stated fuel was in carb via turning drain screw and fuel rushed out drain tube. Carb cleaned twice and yes it is totally clean as stated. And it does sound like a vacuum issue since ...

Thanxs for info....I have recently worked on another spree and with this forums help I totally understand the importance of "a clean carb" .Which is why that one would not run properly after the first carb cleaning. The carb is 100% clean...every port,hole,nuk and cranny.
Not sure what you mean by ...

Hey everyone....86 spree-Has not run in years////New top end and gaskets-Carb cleaned and blown out twice( Every hole is 100% open and yes even the micro small hole :smile: ). Checked spark and looks very good. Tried to kick start ( No Battery in her yet) numerous times and the clear gas line showed ...

Most of my toys run premix and just have never trusted oil pumps on 2strokes. Why do I keep reading about grinding off the teeth on the pump? What is the reason for this?

And the oil hose from the intake to the pump???
Do I leave it attached or plug it up?

Im going premix with my spree and looking for a rough ratio to start at. I read a few pages here looking to see if someone posted it and unless I just missed it I cant find one anywhere. Also since the oil tank will be empty,should I plug up the hose so it doesnt suck any extra air in which would ...