Honda Spree and Elite 50 Forums

Thanks for the reply. I've been to 2 bearing shops, and 6204-W12 will come up on there screen...but they are unavailable. In the past I've ordered Honda part # 91001-GM4-033 and got a 12mm wide bearing. Now that part number shows a 14mm wide bearing. Hopefully I can find one or two before I pull out ...

Greetings everyone! Been a while since I've logged on. I've run into a Spree crankshaft bearing issue. For years I've had to order the drive side crankshaft bearing through Honda. The bearing was a 20x47x12mm. Now dealers and web sites have that bearing as a generic 6204. A 6204 bearing measures ...

Maybe the gas cap vent is plugged

After LOTS of research, the two mentioned wires plug together. It makes no sense, but apparently they do.

Greetings scooterists! I recently aquired a 2008 Honda Metropolitan "basket case". I've got it 85% completed and when wiring the speedometer to the harness, I came across 2 wires coming out of the speedometer that have me stumped. About a 3" green/orange wire with a female bullet connector (high ...

Tried 2 other ignition coils.....no change. Checked thermostat sensor....no change.

I'll check it out. Thanks

It doesn't seem like the cooling system is the problem. The radiator and hoses are warm after running for a few minutes and I get a few air bubbles when bleeding the system. Coolant light on speedometer doesn't come on (tested light and it works). After short ride at 25 mph, motor slows to idle and ...

Tried known good stator, reset data.......no change.

Ahhhh yes, the Spree kickstand removal and reinstall! Usually bloody knuckles and using words not suitable for kids is what happens. Here's what I do. If you have a stand, clamp the front wheel or have someone hold the scooter. With the stand up, remove the cotter key from the right side and slide ...

Picked up a 2007 Honda Metropolitan with 6800 miles,(not a Metropolitan 2), that was stored for 6 years. Has new battery and obviously the carb had to be cleaned and new carb kit and float needle. Starts and idles like new. Everything works. Good throttle response but will not go over 25 mph.When ...

While reviewing this site, I came upon the part about crankshaft bearings that anyone rebuilding a 1986/1987 Honda Spree should be aware of. The drive side bearing stated to be a generic 6204 (20x47x14) is too wide. I tried one a few years ago and the cases will NOT come together. The correct ...

Could be a lot of things.... Is spark plug wet? Check crank seals (left side sometimes comes loose). Does it have compression? Is carb CLEAN? Is air filter in good condition(not crumbly)? Timing correct? It's winter in Minnesota and 2 strokes sometimes don't run in the cold weather. How warm is it ...

Greetings:

Vise Grips could conceivably damage the drive face. Pick up THIS. You can get it much cheaper if you shop. The pins lock the clutch too.


Excellent tool for clutch, drive pulley, flywheel, etc. I've had one for years. One thing about buying tools...You usually forget how much you pay ...

You shouldn't need locktite if you torque the nut down to 30 ft/lbs.