Honda Spree and Elite 50 Forums

Looks similar to an exhaust I have but not sure what mine is either.

From what I read the turbo blue 110 is a leaded gasoline. Was just trying to get a confirmation that it's fine to run leaded gas in my af16. Also when running higher octane will I want to raise or lower jet sizes?

Hello i have been trying unsuccessfully to find some information pertaining to running a mixture of turbo blue 110 octane in my mhr i recently got running. Was planning on doing a 50/50 mixture of 110 and 93 to be on the safe side since the compression on the mhr is higher than the stock bore. Not ...

hi everyone. I picked up an '83 Aero 80 last week and rode it a few times and the other day i decided to open up the cvt cover to check the belt width. When i took the cover off the kickstart came off. The gasket that was on it didnt allow me to see how the gear was on there. There is a little arrow ...

yeah i tried to order a vtcycles bbk a couple months ago and i got no response but from what i read a lot of people dont get responses either so i didnt bother to look into it any further. i also looked into getting the sp3 from sip scooters but it was $110 plus $30 something for shipping and then ...

ok thanks meadows! well me and my buddy both have the day off tomorrow so were going to try and finish putting my top end together( just gotta pick up my circlips from the honda shop) then i should have all of the necessary components to see if this thing will work. i think we will first hook it up ...

meadows i will be using a variated af05e engine that i found on a parts bike. The only downfall is the donor bike was a se50p and if that wasnt bad enough im pretty sure it happens to be the "iowa" version.. im not positive but i think the sticker on the gas tank happened to have the se50p-aa so i ...

thanks again wheelman for all of your input!
So i might jb weld it first like you suggested to see how/if it performs (have to take one for the team and cruise around in the 30 degree weather) if the jb weld doesnt hold is there a possibility the drive face, variator or the belt will get damaged ...

When i went to my local honda dealer i tried to order the intake manifold gasket and they told me that they no longer can get them. so i was just going to buy some gasket material and make my own since it is a pretty basic looking design but that doesn't always translate into being an easy task ...

I know i might get some scrutiny for my new plan but here it goes..
I currently have a set of polini 7.3? gram rollers and a metro vari. i plan on ordering the longer polini 006 belt that wheelman speaks of and then just weld it on there before it gets completely stripped. i know its not a ...

Wow curt looking pretty good! Now you just need to pull the trigger on that replacement metrakit piston and you will be ready to rip.

finally got the picture of the crank splines. hopefully somebody will be able to tell whether or not i can use the engine in the current condition. if not are there any aftermarket cranks that are still available for af05 engines or do i have to try and find a stock crank?

hello im in the process of swapping an af05 into my 83 aero 50. i was just wondering a few things before i throw it all together.
1. will my stock air box work with this new setup? i will be using the stock af05 cylinder with a leovince sp3 exhaust. im sure i will have to make my own mounting ...