Search found 8 matches

by Budster
Mon Nov 26, 2012 11:28 am
Forum: Technical Help
Topic: '86 Spree won't start
Replies: 16
Views: 6532

Re: '86 Spree won't start

"The solution to a carbon-caked exhaust is to de-carbonize. I would avoid unproven modifications that cannot be undone. Drill at your peril."

It WAS perilous riding along at 5 mph. Here in Indiana you are an easy target for half empty beer cans, tobacco spit or corn cobs at that speed.

I knew the ...
by Budster
Mon Nov 26, 2012 2:52 am
Forum: Technical Help
Topic: '86 Spree won't start
Replies: 16
Views: 6532

Re: '86 Spree won't start

My elite would start but had no power, went maybe 5 mph, and would go nuts up on the center stand. I took a chance that the muffler was all clogged up, so drilled a hole up the back end of the pipe ( not really knowing what I was doing but figured it could not hurt the 'performance' any more than ...
by Budster
Fri Nov 16, 2012 12:16 am
Forum: Technical Help
Topic: Spree starts, runs, but dies after a minute or so
Replies: 24
Views: 28804

Re: Spree starts, runs, but dies after a minute or so

thanks for the reply pat but not sure if original poster has resolved his issue. I am taking the carb to get it ultrasounded as someone recommended in another thread. I am assuming sound waves to get the tiny passages clear. oil line is working well, oil is dripping when engine is cranked. fuel line ...
by Budster
Sat Nov 10, 2012 12:40 pm
Forum: Technical Help
Topic: my elite starts, idles high, then dies
Replies: 5
Views: 5269

Re: my elite starts, idles high, then dies

thanks jj. I will get to re-cleaning the carb again. pretty sure I saw daylight (3 am) but maybe emulsion holes in jets not fully clean. Hope the last post wasn't confusing, azndude,about the throttle cable re-installation into top of carb. "I also advise that you take off the carb so you can re ...
by Budster
Sat Nov 10, 2012 12:28 pm
Forum: Technical Help
Topic: Spree starts, runs, but dies after a minute or so
Replies: 24
Views: 28804

Re: Spree starts, runs, but dies after a minute or so

thanks carl. I ordered petcock, installed easily and runs better for a while. still bogs down after 10 minutes of constant throttle babying and will try cleaning carb thoroughly. seems like my other bike is experiencing carb problems too so soon I will be expert in carb cleaning with hopes of ...
by Budster
Sat Oct 27, 2012 1:36 pm
Forum: Technical Help
Topic: my elite starts, idles high, then dies
Replies: 5
Views: 5269

Re: my elite starts, idles high, then dies

Hi all; I always check this site first as it has some of the best info I can find.

I have a linhai powermax and it is doing the same thing as azndude's elite. It starts, dies after 5 seconds but I have to use starter fluid to get it going. I cleaned the carb, checked that fuel was being sucked ...
by Budster
Sat Sep 22, 2012 7:59 am
Forum: Technical Help
Topic: Spree starts, runs, but dies after a minute or so
Replies: 24
Views: 28804

Re: Spree starts, runs, but dies after a minute or so

Hi thought I would jump in here even though it is not my thread but I have a similar problem. 87 elite se50 and it appears there is no petcock at all between tank and carb. Meaning there is a vacuum line that is not being used off the carb. Question is whether that causes the engine to die after ...
by Budster
Sat Sep 22, 2012 7:21 am
Forum: Technical Help
Topic: Spree starts, runs, but dies after a minute or so
Replies: 24
Views: 28804

Re: Spree starts, runs, but dies after a minute or so

Hi thought I would jump in here even though it is not my thread but I have a similar problem. 87 elite se50 and it appears there is no petcock at all between tank and carb. Meaning there is a vacuum line that is not being used off the carb. Question is whether that causes the engine to die after ...