Search found 10 matches
- Sun Aug 04, 2013 7:35 pm
- Forum: Technical Help
- Topic: Cold Start Issue & Oil Consumption Question
- Replies: 8
- Views: 5327
Re: Cold Start Issue & Oil Consumption Question
what is a dio?
- Fri Aug 02, 2013 2:13 pm
- Forum: Technical Help
- Topic: Cold Start Issue & Oil Consumption Question
- Replies: 8
- Views: 5327
Cold Start Issue & Oil Consumption Question
I have an 86 Spree which I recently purchased with 1900 miles on it. I spent a lot of time cleaning the carb, new stock air filter, new battery, replaced old oil in oil tank, replaced old fuel. Got it running and been riding for several weeks but have a couple items I need to resolve.
Easy question ...
Easy question ...
- Tue Jul 02, 2013 10:40 am
- Forum: Technical Help
- Topic: 86' Spree Starts then Dies
- Replies: 12
- Views: 5843
Re: 86' Spree Starts then Dies
Thanks Guys. I appreciat the help.
- Mon Jul 01, 2013 8:56 am
- Forum: Technical Help
- Topic: 86' Spree Starts then Dies
- Replies: 12
- Views: 5843
Re: 86' Spree Starts then Dies
I went back through the carb again and made sure to take "Everything" appart. I could not see the mysterious little hole in the side of the pilot tube. The more I looked for it the more I'm starting to think it doesn't exist. The only way there is a hole in the side of that brass tube along side the ...
- Wed Jun 26, 2013 9:27 am
- Forum: Technical Help
- Topic: 86" Spree Electric Start INOP
- Replies: 3
- Views: 2258
Re: 86" Spree Electric Start INOP
Yes and the brake light comes on when I do.
- Tue Jun 25, 2013 5:38 pm
- Forum: Technical Help
- Topic: 86" Spree Electric Start INOP
- Replies: 3
- Views: 2258
86" Spree Electric Start INOP
I'm still working on getting the motor to run good on my 86' Spree but also have a new problem, the electric start button won't work. I have looked at all the connections to ensure they are tight and not corroded. Everything looks good but it seems electrically dead. I remember reading somewhere in ...
- Fri Jun 21, 2013 12:56 pm
- Forum: Technical Help
- Topic: 86' Spree Starts then Dies
- Replies: 12
- Views: 5843
Re: 86' Spree Starts then Dies
I got it running fairly well last night. I took your advice and re-cleaned the carb (again) and it seemed to run better. I drove it around for about 20 mintues, got it good and hot. Shut it off, started it back up and it ran and idled great. I thought I had fixed it. This afternoon I go out and ...
- Thu Jun 20, 2013 8:51 pm
- Forum: Technical Help
- Topic: 86' Spree Starts then Dies
- Replies: 12
- Views: 5843
Re: 86' Spree Starts then Dies
If the seal is bad on the by-starter, could that cause the engine to run then die? I also noticed the by-starter is warm to the touch, after it runs a couple seconds, is that normal?
- Thu Jun 20, 2013 8:33 pm
- Forum: Technical Help
- Topic: 86' Spree Starts then Dies
- Replies: 12
- Views: 5843
Re: 86' Spree Starts then Dies
Clean the carb again... Sorry...
I notice that the Auto-bystarter is "somewhat" easy to turn even when fully clamped down. I removed it, checked the needle, put it back on the carb. I kicked it and it took off great. Ran great for 10 seconds, allowed me to rev it a few times, then began to act as ...
I notice that the Auto-bystarter is "somewhat" easy to turn even when fully clamped down. I removed it, checked the needle, put it back on the carb. I kicked it and it took off great. Ran great for 10 seconds, allowed me to rev it a few times, then began to act as ...
- Thu Jun 20, 2013 8:07 pm
- Forum: Technical Help
- Topic: 86' Spree Starts then Dies
- Replies: 12
- Views: 5843
86' Spree Starts then Dies
After purchasing a 1986 spree that has sat for the last three years I have been working on it to get it running. I have replaced with all new gas, new oil, new plug, cleaned the airfilter (and taped off top holes in cap per reading other posts on this site), installed new throttle cable, cleaned ...