Honda Spree and Elite 50 Forums

Greetings:

There's a world of difference between 200 and 300. It's not what the temp reads after 5 seconds, but the endpoint temperature at which the top end stabilizes - indefinitely - with the throttle held open. If it looks like it wants to keep climbing past 400, let off and put in a bigger ...

Thanx wheelman Yes I got it mixed up haha
So today I went out I put back the 142main left the 52 pilot in adjusted my air screw 1 1/2 turns out clip all the way down..no bogging sputtering at all on bottom mid top end.temperature went up to 200-300(westach temp gauge)at wot up hill holding it for 5 ...

Greetings:

The main may be a bit small. Do not dismiss the contribution a big pilot adds to the mix, even at WOT. how far is the air screw turned out? If you have no temp gauge, I recommend one. Otherwise the spark plug can give a clue, but sometimes too late.
Thanks wheelman when I had the ...

Hi forum need some jet suggestions I'm running 72cc malossi mhr malossi crank on a AF16e 8:4 gears pg long 28mm oko

Pilot 152 main 142 nice and clean in the beginning sputtering at top end

Pilot 152 main 140 running good but seems lacking top end (no bogg just sluggish)maybe too heavy weight ...

Hi forum need some jet suggestions I'm running 72cc malossi mhr malossi crank on a AF16e 8:4 gears pg long 28mm oko

Pilot 152 main 142 nice and clean in the beginning sputtering at top end

Pilot 152 main 140 running good but seems lacking top end (no bogg just sluggish)maybe too heavy weight ...

veedubh20 wrote:malossi crank... no waste time on taiwan crank..

Howzit veedubh I know the malossi is stronger and will last longer.. But as far as power and top speed?

Mhr malossi 72cc malossi crank VS Mhr malossi 72cc ministroke
On af16e block
If both tuned right which would be faster???

Honda elite

Ryderjames2013 wrote:My Honda elite

86cc Taiwan
Mini stroke ruima
Pg long
28mm oko ct mani
Building new block in the works that's going on this bike

72cc mhr malossi
Malossi crank
Gears?? 7:1? 8:1??
Keli clutch heavy
28mm oko
Ct mani
Pg long/short?

My Honda elite

Thanks for all the advice guys .. I found a friend here who's experienced
With porting mhr's.. gunna start tomorrow.. Thanks again

Thanks pat.. The exhaust port on the mhr looks to small in my
Opinion so I'm gunna open it up a lil..there's 2 lips in the exhaust port
Gunna port it down to the 1st lip.

Thanks guys .. Planning on porting exhaust port..and yes this is my first porting job
Porting the exhaust port can't be to hard..

What's the best bit for porting aluminum(malossi mhr)??

Being that I live here(Maui) I agree ^^^^