Honda Spree and Elite 50 Forums

04 Kymco ZX50
I'm 6'3" 250lbs
Stock gearing: 45mph flat, 51 downhill.

Eh, mine misfires for a bit when I first startup cold. I think it's just because the bystarter is richening it a bit too much. Once I've warmed it up I'm good to go.

A replacement crank shouldn't be much, and it'll be a new crank with new big end bearings and a new conn rod. I think I paid $120ish for mine. With all the bearings and the seals I rebuilt my bottom end for about 200 bucks. You might be better off doing that than bothering with the disassembly ...

^^^ I've got that scooter in red

ANything's possible with the right amount of money and fabrication skills. For example: http://www.honda-tech.com/zerothread?id=2297467

But if you have to ask if something like this is possible, I'm going to bet that you don't have the ability to pull it off. Not only that, but it wouldn't make for ...

Check the for sale section

I have the 28mm carb and intake set that were on my scooter for a couple hours tops. Same setup previous poster recommended.

Sit really far back, twist throttle.

you did something wrong on that setup, my stock italjet dragster does 50mph, sell your scoot to someone in michigan if they can afford it....

Did you not read the post above this? I'm also not going to sell my scooter, why would I? It's doing great.

Everything's working fine. I'm sure if I was ...

I've got a big carb w/ filter, reed valves, intake and throttle cable I'll sell cheap.

BTW, you keep using the word invest. It's not an investment, you will not see any gain or even a significant percentage on return when you try to sell it.

You're also posting about for all practical purposes, useless mods. If you want to do custom aesthetic modifications, you would be better off ...

Everything's running fine, and has been for 600 miles now. I top out at 44 on flatland with no wind, 40 with a crosswind, 38 up hills. I'm 6'3" 230 lbs so I can't complain.

I'm premixing, I had other issues causign the fouling, it's all sorted out. I'm not using the 28mm carb mainly because I don ...

I would love to see the day you actually do just ONE of the things you've made a thread about on here. Anyone can talk, and the questions you're asking and ideas you're tossing out there are not things that would be asked by a person with the ability to actually bring those ideas into reality.

your oil pump should be fine, if it smokes real bad on a cold start then its time to change it, did you take the restrictor ring off the front pulley? also up to 19mm carbs the stock intake is used, your main jet should be a#85 or #87 i can find a set of stock set of honda gears from the shop i ...

I'll sell you my pipe:

http://www.tecnigas.com/model.php?codi=18&cat=2&idioma=en

It's only got 500 miles on her too. May have to fabricate a rear mount set.

I've also got a 19 mm carb setup for that pipe and a 70cc kit.

Heck, $400 shipped I'll sell you my entire setup: cyl kit, exhaust and ...

If you don't mind me asking, what did the PG long pipe cost you?