Honda Spree and Elite 50 Forums

It should bolt up fine.

I just got done dremeling out the bystarter cylinder. Sure enough.. Runs awesome! Hits 29mph on flats and pulls good throughout the rpm range
Thanks alot for the help. I appreciate it!

So the whole problem could be the bystarter getting stuck?

Thanks for the reply. What do you think as for the running badly even with my finger over the hole? Runs perfectly with bystarter completely removed....

No ideas?

Check your slide in the carb, pull the cap off and see if you can get it to move freely, might be binding or needle not seating correctly

I just registered but have been viewing the site since about 5 yrs ago when I bought my first spree. Awesome site! Right now Im working on an 84 that I have had for about 3 years and am determined to get going now. I put new rings and a new cylinder on a few years back(due to exhaust broke off ...