Honda Spree and Elite 50 Forums

No waste of time! Thanks for the help. It was a great write-up, just not specific to this kit. I put the rings on bevel up, and will figure out the rest. Thanks again for the help!

Thanks. I read the whole write-up already and it does not answer my questions. In the write up it is not specific enough.
Jeff

I just bought a top end rebuild kit for my 1985 spree. New cylinder, piston, rings, gaskets etc. The rings have no writing on them. I know that the darker thicker ring goes on top per the seller and the fact it will not fit in the bottom groove, and the smaller shiny ring goes in the bottom groove ...

O.K., not a fuel pump, but a vacuum operated fuel valve. Does anyone know (or can you test yours) how many volts should be going to the bystarter? I checked mine. I removed the bystarter wires and put my meter on the wires it plugs into. I found 2 things: First it only had power when the bike was ...

Hello all,
My 1985 Honda Spree is driving me crazy. It will start perfectly, idle fine, but when you give it throttle it bogs down and will die unless you let off. Sounds like the carb, right? But.... i have cleaned it until its spotless. All the jets are perfect. I am POSITIVE it is clean. It has a ...

I will check the exhaust port. Yeah I would sell my old one. PM me about the details. Anybody have an exhaust?

Also, I can post a pic. of exhaust tomorrow. Just picture the exhaust making its bend after it comes out of the head. Then its about 5 inches past that and its been cut off! Could this affect the power that much? I know when they are plugged it does.

Air filter is clean. I have put in a new plug and it made no difference. Not sure what you mean by a plug chop. I am not even sure if this is the recommended plug. I think its a BPH5HS or something like that. Please elaborate on the plug chop.
Thanks, Jeff

Hello,
I have a 1986 spree. It starts great, idles great. It just has very little power. On the stand you can rev it up and when it gets near full throttle it starts to cut out. I have cleaned the carb and its spotless. I am positive nothings clogged or obstructed. I have played with the air screw ...