Honda Spree and Elite 50 Forums

ok got a new air filter and now perfect

except now my spark plug cap keeps falling off :*:

u think i need a new cap or just a new plug? or both?

ok i turned the mixture screw out just a little and it fixed it pretty much all the way except.

like lets say you are running it wideopen and you let off on the throttle and let it come almost down to idel and then hammer on the throttle then it will bogg. this is the only time it will bogg.

it ...

ok i got the spark problem fixed :peace:

but now i need help on getting the thing to run right.

this is what it does:

it will start fine and will ideal fine

then you try to give it gas then it just boggs, but then if you do it a couple more times it will rev up

but then it will not want to ...

ok do you have or no of any diagrams that show where all the stuff is located at?

ok i got a 1994 elite 50cc. i rebuilt the top end in it and finally got the carb clean :smile:

so i today i tried to get it running right. and here is what it does:

it will start fine and will ideal fine

then you try to give it gas then it just boggs, but then if you do it a couple more times it ...

which way did you blow air threw it with the air nosel?

ok so i have still not ben able to get the pilot jet cleaned i can get it to spray from the place where it lets air on the carb where it suck the air into the engin and if i spray carb cleaner it will spray out the little hole in the bore of the carb. but i still can not get it threw the actual tube ...

ok its getting enough fuel in the bowl i did the test.

so i took the carb apart and cleaned it again but i am wondering i the poilt jet is is a perminent one, and should you be able to see threw it?

i think it might be plugged because i can not stick a needle threw it or get any carb spray to ...

so you think the problem might be its not getting enough fuel in the bowl?

i no its geting fuel to the bowl because while its running i can open the drain and fuel will run out. but ya i will clean the carb. again cant hurt anything.

and on the mixture screw it should be at 1.5 turns out? and does turning it out richin the mixture?

never herd that one :*:

but i would never use it. um just use carb cleaner its not very exspensive and you might use a tooth brush to scrub it?

ok so the reeds might be the problem? is that comon simptons of bad reeds?

and ya i dont like to use the starting fluid but i want to get it stated

1993 elite 50 boggs when you give it throttle. scooter ran then sat a while, and then i got it cheap. rebuilt the top end and now trying to get it to run.

it starts. and sometimes idels well but some times it wont. some times u have to use starting fluid, and some times you dont. it boggs when you ...

goodwill lol how much did you get it for but ya what brad 3 said

i just finished rebuilding my 93 elit 50 cc moped :coolcruise: and now i am trying to get it started the only way to get it to start is to get gas or starting fluid right into the cylinder. then crank it over and it will only start if the throttle is wide open and it will keep running as long as the ...