Honda Spree and Elite 50 Forums

Dear coolgangsta24:
I just got a '88 Honda Pal running just like you and experienced the same problems. From what i know the start from a dead stop is usually slow then as you describe it picks up fast (like mine). Make sure your carb is clean, no vacuum leaks and run with your stock airbox (it ...

Dear Wheelman-111;
You have been down this road before. Followed your instructions to the letter and Scooter running like a top. Keeper came out and needle was moving up and down. I will name my first tank of synthetic 2 stroke oil after you. A million thanx.

While cleaning the carb on the Elite i took out the Throttle Valve to shoot some compressed air down the hole. I put the Valve in backwards by mistake then installed it the right way. The Scooter runs too rich now and i took out the Throttle Valve and the clip is'nt sitting right inside the spring ...

What's tire psi should i run on my '88 Elite E. Tires are 2.75 front and rear. I'm about 175 lbs. Should i use the manuals specs or do you guys know otherwise?

Thanx/Keep the Shiney side up

I've been reading in the posts about adjusting the Needle Clip on the Fuel system on the Elites. I want to check mine because it's running slow, where the * is it?

Thanx

It's a Canadian Honda Pal 50 and i'm wondering if it's worth it to drill out the 2 baffles in the silencer. It also has the variator on the crankend and i'm also wondering if it's restricted>

Thanx.

I was wondering is the 1988 Pal/Elite 50 restricted in the Exhaust system (Washer) that needs to be ground out. The nuts on the head look rusted on real bad. Is it worth it?

Thanx

Just joined Honda Spree/Elite forum and want to say hi. Picked up a 1988 Honda Pal (for free) and am wondering were i can pickup a drive belt. Any help would be welcome. Thanx.