My latest problem

[evilone]

A spree is not a moped it is a scooter.

That reply oughta put him on the right path to fixing his Spree

[toad772]

A spree is not a moped it is a scooter.

That reply oughta put him on the right path to fixing his Spree

Well at least he will know it isn't a moped

[evilone]

True that, i was just giving you a little jab

[crime_spree]

...

[crime_spree]

Just found my dads compression tester..It's pushin 100. That's ok right?

[odinxxix]

114 psi is minimum.

[toad772]

Just found my dads compression tester..It's pushin 100. That's ok right?

How did you do the test?

[odinxxix]

you buy a compression tester, thread it in to your plug hole, and crank in engine for about 15 sec. or about 10 kicks.

[toad772]

you but a compression tester, thread it in to your plug hole, and crank in engine for about 15 sec. or about 10 kicks.

you forgot to mention you do it wide open throttle

[toad772]

you buy a compression tester, thread it in to your plug hole, and crank in engine for about 15 sec. or about 10 kicks.

And I was asking HOW HE DID IT to see if he did it correctly.

[Trafficjamz]

A spree is not a moped it is a scooter.

A spree IS registered the same as a moped, if you live in michigan.

100 does seem low.

I would take it apart and look at the piston rings

[toad772]

A spree is not a moped it is a scooter.

A spree IS registered the same as a moped, if you live in michigan.

100 does seem low.

I would take it apart and look at the piston rings

Registering the same is a lot diff then being the same.

[Trafficjamz]

A spree is not a moped it is a scooter.

A spree IS registered the same as a moped, if you live in michigan.

Registering the same is a lot diff then being the same.

we will call it a NOped then

[toad772]

A spree IS registered the same as a moped, if you live in michigan.

Registering the same is a lot diff then being the same.

we will call it a NOped then

Or or we could now bare with me on this one call it a scooter.

[mustangwagz]

Yah..100 psi (with throttle wide open) is to low for a bbk in my opinion.. keep kickin it over till the needle wont move anymore bryan.

Check head bolts to make sure they're still tight. 8 ft lb's i beleive is correct torque for them but check manual to be sure!

The fuel wont flow outta hose with fuel filter on it, UNLESS you suck on the hose thats below it.. Its a vacuum operated petcock.. The bottom hose requires vacuum in order to open, and allow fuel to flow..so thats why ya aint gettin fuel through it when you let it hang-dangle.