Idle Set Screw On Carb 86 Spree

thadpk · Post by **thadpk** » Thu Mar 17, 2011 9:20 am

The issue I am having is that the idle set screw apparently does not seat tight as when the spree is rode the vibrations turn this screw. If I remember correctly there is supposed to be a rubber washer type around this screw. Any ideas on how to fix this?

bc117 · Post by **bc117** » Thu Mar 17, 2011 12:29 pm

not sure about a rubber piece but there should be a spring that puts pressure on the screw

Bear45-70 · Post by **Bear45-70** » Thu Mar 17, 2011 3:21 pm

bc117 is correct the spring holds the mixture screw in place. And you can NOT buy the spring separate from the screw.

SCREW SET B 16028-GC8-004 about $12.00

thadpk · Post by **thadpk** » Thu Mar 17, 2011 9:05 pm

Thanks Bear, looks like I will be buying a set then as the spring is incognito

Bear45-70 · Post by **Bear45-70** » Fri Mar 18, 2011 12:39 am

You might be able to find a spring of the right size at the hardware store.

thadpk · Post by **thadpk** » Fri Mar 18, 2011 8:25 am

Great idea! I will check that today

Honda Spree and Elite 50 Forums

Idle Set Screw On Carb 86 Spree

Idle Set Screw On Carb 86 Spree

Re: Idle Set Screw On Carb 86 Spree

Re: Idle Set Screw On Carb 86 Spree

Re: Idle Set Screw On Carb 86 Spree

Re: Idle Set Screw On Carb 86 Spree

Re: Idle Set Screw On Carb 86 Spree