spree runs excellant on center stand but wont pull me

[ciccanti38]

me either but 25 years old and never conditioned something gotta go and rubber is the worst thing for dry rot

[Bear45-70]

me either but 25 years old and never conditioned something gotta go and rubber is the worst thing for dry rot

Even 25 years ago O-rings weren't rubber and they only rot (if they were rubber) when exposed to the air, which when squashed between the carb, insulator and intake does not happen.

[ciccanti38]

what you reccomend i do runs fine on stand but not under load

[Trafficjamz]

what you reccomend i do runs fine on stand but not under load

Stripped threads in the carb?

[Trafficjamz]

what you reccomend i do runs fine on stand but not under load

Stripped threads in the carb?

[Bear45-70]

what you reccomend i do runs fine on stand but not under load

Again, what it does on the center stand means NOTHING!

Your main jet fuel circuit is screwed, probably the emulsion tube.

http://hondaspree.net/wiki/index.php5?t ... r_Cleaning

http://hondaspree.net/wiki/index.php5?t ... ture_Guide

[Ricerider]

Just replace the orings, they are 15 cents a piece at the hardware store, ace, true vale etc.
Built a spree for the lady last year, ran good for 200 miles and then started bogging at random, seemed to change depending on engine temp, replaced the orings and and that was it. Research the venturi effect and how carbs work and it will make sense

[ciccanti38]

i understand how the feul system works with vacuum and all that is what seems to be the problem gonna get new o rings today and try it out thanks for the help

[Trafficjamz]

got everything running perfect but wont even pull me on the level has been sitting since last august anyone have an idea whats wrong

Gummed up carb is probably your problem

[ciccanti38]

changed o rings and vacuum line runs pretty good but bogs every now and then think it really needs run time

[Ricerider]

Did you go thru the carb yet? If its your first time it might take hour to do but it well worth it. Get yourself some chemtol at autozone (dont get in eyes ) wear glasses....

Pull out every screw you can find including the tube behind the main jet, you have to push it out the bottom of the carb from the top. It a brass tube about 1" long, there are holes in there that tube that have to be spick and span. Then use a guitar string or piece of wire and verify all channels are clean including the main jet (only flat head screw in there)

I like to spray chemtol in the carb and force it thru with the air compressor, it will mist out the other end and you will know it all clear.

Gummed up carb will lean the engine out, not a question of if it will burn up its when.....

[ciccanti38]

carb was gone thru twice everythings clean all jet all vent holes the more i run it it gets better each time it has been sitting awhile so i think till the carb and the oil injection run itll b fine thanks to all for your help dont usually work on these mainly dirt bikes thought it would be an intriging exp. to take this on

[tru72]

did you check the reed cage?