jetting?

[blaster716]

I just learned that the exhaust on my elite e is restricted , if I remove the restriction what size jet do I use.

[Wheelman-111]

Greetings:

According to Deepinnaharta Honda's Fiche (save this to look up anything you want...), the Mains are 65 and 68 for the P and "Regular" models, respectively. It is reasonable to assume that de-restricting your P model will result in the need for a 68. Remember Honda-san was jetting to the edge of very lean for EPA reasons, so it might be better to go a little bigger, particularly if you open up the airbox or get a tricky pipe.

[KingJeff801]

I have had good success with a 90 jet

[Wheelman-111]

Greetings:

KJ, this is an SB50. It speaks Spree-ish. Maybe a 90 with a big-bore kit and a pod filter, but for sure it's too big for a Stock-ish de-restricted SB.

[KingJeff801]

Greetings:

KJ, this is an SB50. It speaks Spree-ish. Maybe a 90 with a big-bore kit and a pod filter, but for sure it's too big for a Stock-ish de-restricted SB.

Didn't have the contacts in....I thought is was an S

[Bear45-70]

Greetings:

KJ, this is an SB50. It speaks Spree-ish. Maybe a 90 with a big-bore kit and a pod filter, but for sure it's too big for a Stock-ish de-restricted SB.

Didn't have the contacts in....I thought is was an S

You need a big screen like I have so those letters aren't so small.

[blaster716]

So Im assuming that a 68 jet would do the job?