85 spree issues
Moderator: Moderator
- the0captain
- Spree
- Posts: 144
- Joined: Mon Jun 13, 2011 10:18 am
- Location: far away from bear
Re: 85 spree issues
Exhaust gasket is replaced and now it syarts right up and idles well but as soon as you give it gas it just wants to die. So what am i over looking?
- swimmingfree
- CBR1000RR
- Posts: 3065
- Joined: Tue Jun 14, 2011 12:28 pm
- Location: mich.
Re: 85 spree issues
i no it sounds like bull but it not
if the lid not on or the tube the goes from the carb to the air box is not clamp on or the air filter is not in or out of place it will do that
in short its going to run len
swimmingfree
if the lid not on or the tube the goes from the carb to the air box is not clamp on or the air filter is not in or out of place it will do that
in short its going to run len
swimmingfree
handicap (dyslexia)
looking for
se50 crank...
SpreJunk 87elite in a spree body
ruckus variator , 3.5 tire , 1500 drive face spring , a 64 bbk ,
8 gram rollers, stock carb , after market air filter and 105 jet
looking for
se50 crank...
SpreJunk 87elite in a spree body
ruckus variator , 3.5 tire , 1500 drive face spring , a 64 bbk ,
8 gram rollers, stock carb , after market air filter and 105 jet
- the0captain
- Spree
- Posts: 144
- Joined: Mon Jun 13, 2011 10:18 am
- Location: far away from bear
Re: 85 spree issues
yes, i've tried all of that. even taped up the airbox to make sure it was sealed.swimmingfree wrote:i no it sounds like bull but it not
if the lid not on or the tube the goes from the carb to the air box is not clamp on or the air filter is not in or out of place it will do that
in short its going to run len
swimmingfree
- swimmingfree
- CBR1000RR
- Posts: 3065
- Joined: Tue Jun 14, 2011 12:28 pm
- Location: mich.
Re: 85 spree issues
were is the pin on the throttle valve set ?
handicap (dyslexia)
looking for
se50 crank...
SpreJunk 87elite in a spree body
ruckus variator , 3.5 tire , 1500 drive face spring , a 64 bbk ,
8 gram rollers, stock carb , after market air filter and 105 jet
looking for
se50 crank...
SpreJunk 87elite in a spree body
ruckus variator , 3.5 tire , 1500 drive face spring , a 64 bbk ,
8 gram rollers, stock carb , after market air filter and 105 jet
- the0captain
- Spree
- Posts: 144
- Joined: Mon Jun 13, 2011 10:18 am
- Location: far away from bear
Re: 85 spree issues
middleswimmingfree wrote:were is the pin on the throttle valve set ?
- swimmingfree
- CBR1000RR
- Posts: 3065
- Joined: Tue Jun 14, 2011 12:28 pm
- Location: mich.
Re: 85 spree issues
shod be one up from the bottom... i run mine on the bottom
swimmingfree
swimmingfree
handicap (dyslexia)
looking for
se50 crank...
SpreJunk 87elite in a spree body
ruckus variator , 3.5 tire , 1500 drive face spring , a 64 bbk ,
8 gram rollers, stock carb , after market air filter and 105 jet
looking for
se50 crank...
SpreJunk 87elite in a spree body
ruckus variator , 3.5 tire , 1500 drive face spring , a 64 bbk ,
8 gram rollers, stock carb , after market air filter and 105 jet
- swimmingfree
- CBR1000RR
- Posts: 3065
- Joined: Tue Jun 14, 2011 12:28 pm
- Location: mich.
Re: 85 spree issues
as it sit in the carb
handicap (dyslexia)
looking for
se50 crank...
SpreJunk 87elite in a spree body
ruckus variator , 3.5 tire , 1500 drive face spring , a 64 bbk ,
8 gram rollers, stock carb , after market air filter and 105 jet
looking for
se50 crank...
SpreJunk 87elite in a spree body
ruckus variator , 3.5 tire , 1500 drive face spring , a 64 bbk ,
8 gram rollers, stock carb , after market air filter and 105 jet
- the0captain
- Spree
- Posts: 144
- Joined: Mon Jun 13, 2011 10:18 am
- Location: far away from bear
Re: 85 spree issues
yup, one up from the bottom is the middleswimmingfree wrote:shod be one up from the bottom... i run mine on the bottom
swimmingfree
Re: 85 spree issues
hahha swimmingfree........you ran yours on the bottom all right ..........then it puked up its piston 

1986 Spree/ Eve af16 swapped 65cc Prodigy vari 8g 9:1 Ruima gears
21mm OKO 42/100 32:1 45mph kymco zx exhaust
1994 Elite S 17.5mm Arreche, Daytona reeds, SEF ramp, pump plugged
1987 Elite SE50 af16 swapped
1989 Elite E SB50p
2003 Yamaha Zuma
21mm OKO 42/100 32:1 45mph kymco zx exhaust
1994 Elite S 17.5mm Arreche, Daytona reeds, SEF ramp, pump plugged

1987 Elite SE50 af16 swapped
1989 Elite E SB50p
2003 Yamaha Zuma
Re: 85 spree issues
maybe you have a leak around the manifold, taking those carbs on and off cant be good on the orings. I say this because i think mine is leaking there too with the other gaskets. i put some silicon on there this morning waiting for it to set. you might try that if you are out of options 

1986 Spree/ Eve af16 swapped 65cc Prodigy vari 8g 9:1 Ruima gears
21mm OKO 42/100 32:1 45mph kymco zx exhaust
1994 Elite S 17.5mm Arreche, Daytona reeds, SEF ramp, pump plugged
1987 Elite SE50 af16 swapped
1989 Elite E SB50p
2003 Yamaha Zuma
21mm OKO 42/100 32:1 45mph kymco zx exhaust
1994 Elite S 17.5mm Arreche, Daytona reeds, SEF ramp, pump plugged

1987 Elite SE50 af16 swapped
1989 Elite E SB50p
2003 Yamaha Zuma
- swimmingfree
- CBR1000RR
- Posts: 3065
- Joined: Tue Jun 14, 2011 12:28 pm
- Location: mich.
Re: 85 spree issues
the faster it gose the faster it gose boooom
my spree by the spedo 32
youe stock spree?
my spree by the spedo 32
youe stock spree?
handicap (dyslexia)
looking for
se50 crank...
SpreJunk 87elite in a spree body
ruckus variator , 3.5 tire , 1500 drive face spring , a 64 bbk ,
8 gram rollers, stock carb , after market air filter and 105 jet
looking for
se50 crank...
SpreJunk 87elite in a spree body
ruckus variator , 3.5 tire , 1500 drive face spring , a 64 bbk ,
8 gram rollers, stock carb , after market air filter and 105 jet
Re: 85 spree issues
yup stock figured i would mess with it today while I am waiting on the carb rebuild kit and exhaust gasket for the Eve
when i break the eve in i may sell the stock spree to this lady police officer that told me she wanted to buyy it for her daughter cause she had one when she was a kid 


1986 Spree/ Eve af16 swapped 65cc Prodigy vari 8g 9:1 Ruima gears
21mm OKO 42/100 32:1 45mph kymco zx exhaust
1994 Elite S 17.5mm Arreche, Daytona reeds, SEF ramp, pump plugged
1987 Elite SE50 af16 swapped
1989 Elite E SB50p
2003 Yamaha Zuma
21mm OKO 42/100 32:1 45mph kymco zx exhaust
1994 Elite S 17.5mm Arreche, Daytona reeds, SEF ramp, pump plugged

1987 Elite SE50 af16 swapped
1989 Elite E SB50p
2003 Yamaha Zuma
- swimmingfree
- CBR1000RR
- Posts: 3065
- Joined: Tue Jun 14, 2011 12:28 pm
- Location: mich.
Re: 85 spree issues
hay when you sell it dose it come with a case of duck tape and a spool of balling wire .. you do no that they will need it 

handicap (dyslexia)
looking for
se50 crank...
SpreJunk 87elite in a spree body
ruckus variator , 3.5 tire , 1500 drive face spring , a 64 bbk ,
8 gram rollers, stock carb , after market air filter and 105 jet
looking for
se50 crank...
SpreJunk 87elite in a spree body
ruckus variator , 3.5 tire , 1500 drive face spring , a 64 bbk ,
8 gram rollers, stock carb , after market air filter and 105 jet
Re: 85 spree issues
Not all needles have five notches, some only have 3.swimmingfree wrote:shod be one up from the bottom... i run mine on the bottom
swimmingfree
Bear 45/70

'83 Aero 80 X 3
'84 Aero 80 X 3
'85 Aero 80
'84 Aero 125 X 2
'84 Aero 125
'84 Aero 125 X 2
'85 Aero 50
'85 Spree

'83 Aero 80 X 3
'84 Aero 80 X 3
'85 Aero 80
'84 Aero 125 X 2
'84 Aero 125
'84 Aero 125 X 2
'85 Aero 50
'85 Spree
- swimmingfree
- CBR1000RR
- Posts: 3065
- Joined: Tue Jun 14, 2011 12:28 pm
- Location: mich.
Re: 85 spree issues
is that by year ?? or by the midrange jet.. i think that what it is???
handicap (dyslexia)
looking for
se50 crank...
SpreJunk 87elite in a spree body
ruckus variator , 3.5 tire , 1500 drive face spring , a 64 bbk ,
8 gram rollers, stock carb , after market air filter and 105 jet
looking for
se50 crank...
SpreJunk 87elite in a spree body
ruckus variator , 3.5 tire , 1500 drive face spring , a 64 bbk ,
8 gram rollers, stock carb , after market air filter and 105 jet