Spree bogging down with air filter?

[martynkim]

It sounds like it is still running lean. Pull the plug and describe the color and condition. Pics are even better.

[Bear45-70]

Replace your fuel lines and clean the inlet to the needle and seat. Today's fuel destroys the inside of the old fuel lines and bits and pieces flake off.

[OptimusRhymes]

So i tore apart the carb and cleaned it well. I also removed the main jet and it looks like it is a 65? I took the scooter for a ride afterwards and it still was bogging down... adjustments? different jet? What do I have to do to get this thing running the way it should? Thanks for your help guys

[swimmingfree]

you mat think we dont no what we are doing but
pull the f***ing plug and tell us what color it is!!!

[OptimusRhymes]

Ok, so i finally got the plug out and its very oily and black. the plug type is Bpr6hsa. I also took a picture

http://i148.photobucket.com/albums/s26/ ... akPLug.jpg

[OptimusRhymes]

BUMP

[OptimusRhymes]

From doing a little more research, it looks like my plug color means that it is too rich, meaning the carb needs adjusted... can someone instruct me on what exactly i need to adjust? Also if the jet is the one that is supposed to be in there (65) and the plug is correct (Bpr6hsa). thanks

[Bear45-70]

Depends on whether you did a proper plug chop and at what throttle setting you did the plug chop.

[OptimusRhymes]

Depends on whether you did a proper plug chop and at what throttle setting you did the plug chop.

care to elaborate on that a little bit bear?

[Bear45-70]

Depends on whether you did a proper plug chop and at what throttle setting you did the plug chop.

care to elaborate on that a little bit bear?

Did you do an actual plug chop or just ride the scooter and then bring it to a stop, letting it idle, then shut off the motor.

Plug chop info here;

http://hondaspree.net/wiki/index.php5?t ... Plug_Chops

[OptimusRhymes]

I did not do a plug chop. Could i do this with the scooter on its rear stand or is it best to be moving?

[Bear45-70]

I did not do a plug chop. Could i do this with the scooter on its rear stand or is it best to be moving?

If you want bogus info, then do it on the center stand.

[OptimusRhymes]

ok, so i wasnt able to do a full "plug chop" but i was able to put a brand new bpr6hsa spark plug in the spree and ride it around the block a few times... the scooter acted up after about 2 minutes and stalled out on me. I pulled the plug and it is whitish on the top. Here is a link to a picture for you to look at. Next step to solving this problem? I really appreciate the help

http://i148.photobucket.com/albums/s26/ ... gtest1.jpg

[OptimusRhymes]

bumpppp