Panel designing

Dtaylor · Post by **Dtaylor** » Mon May 01, 2006 3:42 pm

I am missing both side panels for my Elite SB. I need suggestions on replacement. I cannot afford new paels, here's the parts I have access to:
-metal piping
-sheet metal
-metal rods
-welder

fizzle · Post by **fizzle** » Mon May 01, 2006 6:07 pm

sheet metal and a few hamers and dollies and bags full of sand, and you should be able to pull of something that will cover your needs, then off course you'll need to cut off the excess.
let us all see how it turns out.
sheet aluminum - wicked cheap and wicked easy to hammer out.
just a tip - oh and its light.
okay stay safe - wear gloves.

mopedman · Post by **mopedman** » Tue May 02, 2006 10:01 am

um that would be hard but would be sweet if you got it to work, did you see if there are any on ebay

prattj1 · Post by **prattj1** » Wed May 03, 2006 12:06 am

If I were in your position I would make a body out of foam. Anything from Godzilla to a trojan horse.

deathwish · Post by **deathwish** » Wed May 03, 2006 10:47 pm

MySpree · Post by **MySpree** » Thu May 04, 2006 8:06 am

if i was in that situation, id just wait for ebay.

myhonda · Post by **myhonda** » Thu May 04, 2006 11:41 pm

i was in that situation. pics in the moped pics topic

Honda Spree and Elite 50 Forums

Panel designing

Panel designing

body panels