Rich Starting NN50 Engine

Trying to get your Spree/Elite to run, or run better? Post your questions here.

Moderator: Moderator

Post Reply
kev
BMX
BMX
Posts: 33
Joined: Sat Apr 30, 2011 4:50 am
Location: kentucky

Rich Starting NN50 Engine

Post by kev »

Hello, NN50 Gyro to rich to start, tuning carb no help, removed air box cover and filter element tuned
carb to start up settings, engine started with very little smoke most likely to lean. Reinstalled
filter and cover, engine would not start, pressurrized air box with 20 psi air, engine would start.
Is the carburator the only problem this could be?
Thanks, Kev
mousewheels
Veteran OG
Veteran OG
Posts: 3485
Joined: Tue May 22, 2007 8:10 pm
Location: North of Seattle, WA

Re: Rich Starting NN50 Engine

Post by mousewheels »

Carb is a likely problem.

A high float level, or a slight leak in the float needle seal issue can make for a rich start condition. I had one carb where the seat had been damaged. It would not seal even when cleaned and a new needle was installed.
kev
BMX
BMX
Posts: 33
Joined: Sat Apr 30, 2011 4:50 am
Location: kentucky

Re: Rich Starting NN50 Engine

Post by kev »

Looks like I overlooked the bystarter it shows a resistance of 20 ohms should be 10 ohms.
I will replace it and start tuneup again.
Kev
Post Reply