Looking for 70cc polini big bore advice
Moderator: Moderator
- spree picker
- BMX

- Posts: 40
- Joined: Tue Sep 27, 2011 9:34 am
- Location: missouri
Looking for 70cc polini big bore advice
I have a 2001 elite I bought that already has the kit.whats is the best spark plug to run and were should the idle air screw be set at
I give old Sprees a new life
Re: Looking for 70cc polini big bore advice
need to get ngk b8hs.
what you plan to run on the motor setup?
what you plan to run on the motor setup?
- spree picker
- BMX

- Posts: 40
- Joined: Tue Sep 27, 2011 9:34 am
- Location: missouri
Re: Looking for 70cc polini big bore advice
It's already set up carb,intake reads and polini belt variator and red clutch spring and v8 pipe
I give old Sprees a new life
Re: Looking for 70cc polini big bore advice
just run 32:1 premix.
- scottinscotty
- Spree

- Posts: 217
- Joined: Tue Oct 12, 2010 9:51 pm
Re: Looking for 70cc polini big bore advice
i'm still running my oil injection... and love it! ... i wouldn't recommend on pre-mixing 32-1 .. but that's up to you!
72cc polini contesa kit
oko variator with 8.5 gram malossi weights
21mm Black Oko Carb & Ct Manifold
8.44 gear
malossi MHR exhaust
Dio zx trans conversion
1000 center spring
1500 grabbers
sef ramp plate
B9hs plug
GPS 60mph
oko variator with 8.5 gram malossi weights
21mm Black Oko Carb & Ct Manifold
8.44 gear
malossi MHR exhaust
Dio zx trans conversion
1000 center spring
1500 grabbers
sef ramp plate
B9hs plug
GPS 60mph
- scottinscotty
- Spree

- Posts: 217
- Joined: Tue Oct 12, 2010 9:51 pm
Re: Looking for 70cc polini big bore advice
and if it has the stock carb.. i'd probably go with a b9hs i would buy a bigger carb though, the pilot jet in your stock carb is migty small for that cylinder and you may risk seizure when you let off the throttle after a long wot. run!
72cc polini contesa kit
oko variator with 8.5 gram malossi weights
21mm Black Oko Carb & Ct Manifold
8.44 gear
malossi MHR exhaust
Dio zx trans conversion
1000 center spring
1500 grabbers
sef ramp plate
B9hs plug
GPS 60mph
oko variator with 8.5 gram malossi weights
21mm Black Oko Carb & Ct Manifold
8.44 gear
malossi MHR exhaust
Dio zx trans conversion
1000 center spring
1500 grabbers
sef ramp plate
B9hs plug
GPS 60mph
- scottinscotty
- Spree

- Posts: 217
- Joined: Tue Oct 12, 2010 9:51 pm
Re: Looking for 70cc polini big bore advice
i'd start with 1 & 1/4 turns out on the idle air scew..
72cc polini contesa kit
oko variator with 8.5 gram malossi weights
21mm Black Oko Carb & Ct Manifold
8.44 gear
malossi MHR exhaust
Dio zx trans conversion
1000 center spring
1500 grabbers
sef ramp plate
B9hs plug
GPS 60mph
oko variator with 8.5 gram malossi weights
21mm Black Oko Carb & Ct Manifold
8.44 gear
malossi MHR exhaust
Dio zx trans conversion
1000 center spring
1500 grabbers
sef ramp plate
B9hs plug
GPS 60mph
- Trafficjamz
- CBR1000RR

- Posts: 5013
- Joined: Tue Jul 14, 2009 7:53 pm
- Location: Eastlake, MI
- Contact:
Re: Looking for 70cc polini big bore advice
How does your oil pump run to your ct mani? did you tap a second hole?scottinscotty wrote:i'm still running my oil injection... and love it! ... i wouldn't recommend on pre-mixing 32-1 .. but that's up to you!
I wouldn't dare run the stock oil pump on my 72cc polini.
It can only mix the oil and gas at about 70:1
new best 1/8th mile time 9.647 seconds @67.155 mph 310lbs total weight
- Trafficjamz
- CBR1000RR

- Posts: 5013
- Joined: Tue Jul 14, 2009 7:53 pm
- Location: Eastlake, MI
- Contact:
Re: Looking for 70cc polini big bore advice
The idle should be set so that the tire does not spin while on the centerstand.spree picker wrote:I have a 2001 elite I bought that already has the kit.whats is the best spark plug to run and were should the idle air screw be set at
new best 1/8th mile time 9.647 seconds @67.155 mph 310lbs total weight
- scottinscotty
- Spree

- Posts: 217
- Joined: Tue Oct 12, 2010 9:51 pm
Re: Looking for 70cc polini big bore advice
Taped a second hole.... I've put almost 2000 miles on my kit with the stock oil pump...
72cc polini contesa kit
oko variator with 8.5 gram malossi weights
21mm Black Oko Carb & Ct Manifold
8.44 gear
malossi MHR exhaust
Dio zx trans conversion
1000 center spring
1500 grabbers
sef ramp plate
B9hs plug
GPS 60mph
oko variator with 8.5 gram malossi weights
21mm Black Oko Carb & Ct Manifold
8.44 gear
malossi MHR exhaust
Dio zx trans conversion
1000 center spring
1500 grabbers
sef ramp plate
B9hs plug
GPS 60mph
Re: Looking for 70cc polini big bore advice
Everyone has their own idea on oil ratios and if it works great!
I run 42.5:1
Why 42.5:1? Because I am lazy and thats 3 oz per gallon. Run it in everything from my weed wacker to my drag scooters and never had a lube related failure.. not saying I never wrecked anything but that always came down to operator error
I run 42.5:1
Why 42.5:1? Because I am lazy and thats 3 oz per gallon. Run it in everything from my weed wacker to my drag scooters and never had a lube related failure.. not saying I never wrecked anything but that always came down to operator error
Re: Looking for 70cc polini big bore advice
What carb,manifold and reeds are you using?spree picker wrote:It's already set up carb,intake reads and polini belt variator and red clutch spring and v8 pipe
Nothing like getting stroked!
Thanks to my sponsors
Nos Energy Drinks,themopedcompany.com,nwautoevents.com,Cycle Gear
90 honda dio sp 72cc
87 elite 50 s with 86cc watercooled mini stroke
87 elite 50 race bike mhr 72cc
91 yamaha tzr 250r
Thanks to my sponsors
Nos Energy Drinks,themopedcompany.com,nwautoevents.com,Cycle Gear
90 honda dio sp 72cc
87 elite 50 s with 86cc watercooled mini stroke
87 elite 50 race bike mhr 72cc
91 yamaha tzr 250r
- spree picker
- BMX

- Posts: 40
- Joined: Tue Sep 27, 2011 9:34 am
- Location: missouri
- kingkamehameha
- CB900F

- Posts: 1005
- Joined: Sat Apr 16, 2011 1:11 pm
- Location: kailua kona
Re: Looking for 70cc polini big bore advice
Do not use the stock pump its asking for troublescottinscotty wrote:Taped a second hole.... I've put almost 2000 miles on my kit with the stock oil pump...
ua mau ke 'ea o ka aina i ka pono o hawaii
- spree picker
- BMX

- Posts: 40
- Joined: Tue Sep 27, 2011 9:34 am
- Location: missouri