fuel petcock problem

Trying to get your Spree/Elite to run, or run better? Post your questions here.

Moderator: Moderator

Post Reply
trudeau1111
BMX
BMX
Posts: 33
Joined: Wed May 09, 2012 2:14 am
Location: atlanta, ga

fuel petcock problem

Post by trudeau1111 »

OK, so, just got it running for first time. BUT....

the petcock is actin crazy....first it would run at idle then quit (after bowl ran dry i think)
then, it filled engine with fuel......
now i unhook both lines from the petcock and both have fuel running out.

anything i can do? recommendations?
trudeau1111
BMX
BMX
Posts: 33
Joined: Wed May 09, 2012 2:14 am
Location: atlanta, ga

Re: fuel petcock problem

Post by trudeau1111 »

yea, i think the float & needle are working correctly.
do you guys keep stock petcock or put on a manual one?
?????
User avatar
dun rite
Board Supporter
Board Supporter
Posts: 662
Joined: Fri Apr 15, 2011 2:07 pm
Location: Naalehu, Hi

Re: fuel petcock problem

Post by dun rite »

replacements are inexpensive (made in china), although some do use a manual shut off valve with success. I replaced mine 'cause I'm afraid I'll forget to shut off the manual one.
taz 50mm bbk, 51g. rollers,1500 c spring
24mm arreche, #20 pilot, E2 needle clip on lower groove
arreche air filter
Naruku intake, reeds & block
v8 pipe
stock gears
trail tech temp & rpm gauges
trudeau1111
BMX
BMX
Posts: 33
Joined: Wed May 09, 2012 2:14 am
Location: atlanta, ga

Re: fuel petcock problem

Post by trudeau1111 »

OK, what i did was drill out the faulty stock petcock, install inline filter, and shutoff valve. test run.........scoot runs good.
Post Reply