82cc af18 question

[Trafficjamz]

Get a ministroker crank and it will clear the ports

or you can shave the block.

[Bear45-70]

Get a ministroker crank and it will clear the ports

or you can shave the block.

Shaving the block would make the port problem worst.

[maddog]

and thats comimg from an expert= never listen to the bear

[Mystic]

If it doesnt have any extra base gaskets then yea add them till its right, those 50mm kits are usually made for stroker cranks and that pipe is for like 50-72cc if I am not mistaken also stripped sparkplug threads can never be good for performance

[Trafficjamz]

Get a ministroker crank and it will clear the ports

or you can shave the block.

Shaving the block would make the port problem worst.

Oops.......yeah adding basegaskets would solve your issue.

[paulpauly7]

make them

[Mystic]

yes you risk burning a hole in your piston or seizure from overheating and preignition. Under high compression pump gas can explode from the heat and being compressed before the spark even fires especially with the stock head since it concentrates the squish area and spark closer to the center of the piston crown. You can take the head to a machine shop and get it machined out to 50mm and not worry about ordering a new one

[Wheelman-111]

Greetings:

Unless you're burning AvGas, don't even start that engine with that high compression.

[Bear45-70]

Greetings:

Unless you're burning AvGas, don't even start that engine with that high compression.

And isn't talking the cheap 87 octane stuff either.

[kryptonite]

Or just raise the jug ... now i have a wicked 82cc af16 build, 1/8 mile 11.21 @ 56.8 mph

[Trafficjamz]

Or just raise the jug ... now i have a wicked 82cc af16 build, 1/8 mile 11.21 @ 56.8 mph

What pipe are you running?

Sent from my DROID RAZR using Tapatalk 2

medium scorpion pipe.

[Trafficjamz]

I just ordered a 32mm v8 pipe. Hopefully it helps, I'm running a 26mm now. What jets are you running? I think I'm 130/48


Sent from my DROID RAZR using Tapatalk 2

the v8 pipe is alot different than the scorpion pipe. The jetting is also different.

kryptonite's jetting is 145/45 iirc

[kryptonite]

i have a scorpian pipe

and yes my jugg is raised also cuz i have a stock crank, ALOT of work is put into this iugg, but back a few years ago id run mid 13's @ 45ish mph, so yea i was getting my * handed to me by a mini stroke 50mm (86cc) untill now he cant catch me hehehe

-Ben

[Trafficjamz]

i was getting my * handed to me by a mini stroke 50mm (86cc) untill now he cant catch me hehehe

-Ben

Don't setup your scooter up like kryptonite, his is a race only setup.

If you plan to just cruise aim for about 120psi

@Ben
Get ready to have your * handed to you again before the year is over new old superman is making a comeback!

[kryptonite]

ooo dang id better find a frame for the 82cc then... im not worried