1994 Honda elite SR won't start.

Trying to get your Spree/Elite to run, or run better? Post your questions here.

Moderator: Moderator

Post Reply
birdman3131
Noob
Noob
Posts: 4
Joined: Wed Nov 14, 2012 9:36 am
Location: Arkansas

1994 Honda elite SR won't start.

Post by birdman3131 »

Ok I have a 1994 honda elite sr that will not start. Some of the wireing has been modified and I am not sure if it is the wireing or a carb issue. What would be the bare basic wires I need to have hooked up to get it to start? It does have spark and the spark plug is new. No battery but the kick start works to turn the motor and cause spark.

And if it is the carb what do I need to keep an eye out for?

I can get pictures iff needed
The scooter did run right before I got it but died and would never start again.
User avatar
swimmingfree
CBR1000RR
CBR1000RR
Posts: 3065
Joined: Tue Jun 14, 2011 12:28 pm
Location: mich.

Re: 1994 Honda elite SR won't start.

Post by swimmingfree »

handicap (dyslexia)
looking for
se50 crank...

SpreJunk 87elite in a spree body
ruckus variator , 3.5 tire , 1500 drive face spring , a 64 bbk ,
8 gram rollers, stock carb , after market air filter and 105 jet
birdman3131
Noob
Noob
Posts: 4
Joined: Wed Nov 14, 2012 9:36 am
Location: Arkansas

Re: 1994 Honda elite SR won't start.

Post by birdman3131 »

So I just attach the tester and start pumping the kick starter for 30-60 seconds? Asking cause I don't have a battery.
User avatar
paulpauly7
CB900F
CB900F
Posts: 1684
Joined: Tue Feb 21, 2012 6:57 pm
Location: nz

Re: 1994 Honda elite SR won't start.

Post by paulpauly7 »

with the throtttle wide open
86 Nifty Fifty (spree)
ZX disk brake
Kitico 120kmh speedo
AF18 ZX ported
Polini corsa
Malossi crank
CTmani
24mmOKO
40pilot118main
Scorpion pipe
8.44 to 1
Michelin s1
71.3mph
92 yz125, 94 crm250
User avatar
Wheelman-111
Moderator
Moderator
Posts: 10683
Joined: Wed Oct 22, 2008 5:09 pm
Location: Deepinnaharta, Texas

Re: 1994 Honda elite SR won't start.

Post by Wheelman-111 »

Greetings:

Throttle open wide, or just remove the carb. Reeds must remain in place.
Kicking will cause the pressure gauge indicator to rise a little less with each kick. Note where it stops rising altogether and that's your compression PSI.
Wheelman-111
Most of my money is spent on scooterparts. The rest is just wasted.
"ISO": '03 Vespa ET4 Malossi187 74MPH
Flash 9: 2001 Elite SR Contesta 72 ZX Tran, 9:1 Gears, Stock Airbox/Carb/Pipe 58.8 MPH
Punkin: 2010 Vespa/Malossi S78, 61MPH
birdman3131
Noob
Noob
Posts: 4
Joined: Wed Nov 14, 2012 9:36 am
Location: Arkansas

Re: 1994 Honda elite SR won't start.

Post by birdman3131 »

well s***. im only getting 35psi. also found that the piston had apperently hit the spark plug. how much is a new piston and where should i get one?
User avatar
sc94elite
Noob
Noob
Posts: 19
Joined: Thu Oct 18, 2012 9:46 am
Location: Sumter,SC

Re: 1994 Honda elite SR won't start.

Post by sc94elite »

greetings


Powersportsplus.com has the stock piston if that's what you want. or you can go bbk you should check the cylinder for scores and replace the rings while you're at it. Find out why the plug hit the piston. Maybe the wrong plug was used?
birdman3131
Noob
Noob
Posts: 4
Joined: Wed Nov 14, 2012 9:36 am
Location: Arkansas

Re: 1994 Honda elite SR won't start.

Post by birdman3131 »

Well I am back. I put in the proper sparkplug and it started right up and I have been running it. Give me a couple weeks and I may look into a few performance upgrades.
Post Reply