Ok I have a 1994 honda elite sr that will not start. Some of the wireing has been modified and I am not sure if it is the wireing or a carb issue. What would be the bare basic wires I need to have hooked up to get it to start? It does have spark and the spark plug is new. No battery but the kick start works to turn the motor and cause spark.
And if it is the carb what do I need to keep an eye out for?
I can get pictures iff needed
The scooter did run right before I got it but died and would never start again.
1994 Honda elite SR won't start.
Moderator: Moderator
-
birdman3131
- Noob

- Posts: 4
- Joined: Wed Nov 14, 2012 9:36 am
- Location: Arkansas
- swimmingfree
- CBR1000RR

- Posts: 3065
- Joined: Tue Jun 14, 2011 12:28 pm
- Location: mich.
Re: 1994 Honda elite SR won't start.
you need to do a compression test...http://hondaspree.net/wiki/index.php5?t ... sion_Check
this may help you clean the carb..
http://hondaspree.net/wiki/index.php5?t ... r_Cleaning
http://hondaspree.net/wiki/index.php5?t ... ture_Guide
swimmingfree
this may help you clean the carb..
http://hondaspree.net/wiki/index.php5?t ... r_Cleaning
http://hondaspree.net/wiki/index.php5?t ... ture_Guide
swimmingfree
handicap (dyslexia)
looking for
se50 crank...
SpreJunk 87elite in a spree body
ruckus variator , 3.5 tire , 1500 drive face spring , a 64 bbk ,
8 gram rollers, stock carb , after market air filter and 105 jet
looking for
se50 crank...
SpreJunk 87elite in a spree body
ruckus variator , 3.5 tire , 1500 drive face spring , a 64 bbk ,
8 gram rollers, stock carb , after market air filter and 105 jet
-
birdman3131
- Noob

- Posts: 4
- Joined: Wed Nov 14, 2012 9:36 am
- Location: Arkansas
Re: 1994 Honda elite SR won't start.
So I just attach the tester and start pumping the kick starter for 30-60 seconds? Asking cause I don't have a battery.swimmingfree wrote:you need to do a compression test...http://hondaspree.net/wiki/index.php5?t ... sion_Check
this may help you clean the carb..
http://hondaspree.net/wiki/index.php5?t ... r_Cleaning
http://hondaspree.net/wiki/index.php5?t ... ture_Guide
swimmingfree
- paulpauly7
- CB900F

- Posts: 1684
- Joined: Tue Feb 21, 2012 6:57 pm
- Location: nz
Re: 1994 Honda elite SR won't start.
with the throtttle wide open
86 Nifty Fifty (spree)
ZX disk brake
Kitico 120kmh speedo
AF18 ZX ported
Polini corsa
Malossi crank
CTmani
24mmOKO
40pilot118main
Scorpion pipe
8.44 to 1
Michelin s1
71.3mph
92 yz125, 94 crm250
ZX disk brake
Kitico 120kmh speedo
AF18 ZX ported
Polini corsa
Malossi crank
CTmani
24mmOKO
40pilot118main
Scorpion pipe
8.44 to 1
Michelin s1
71.3mph
92 yz125, 94 crm250
- Wheelman-111
- Moderator

- Posts: 10683
- Joined: Wed Oct 22, 2008 5:09 pm
- Location: Deepinnaharta, Texas
Re: 1994 Honda elite SR won't start.
Greetings:
Throttle open wide, or just remove the carb. Reeds must remain in place.
Kicking will cause the pressure gauge indicator to rise a little less with each kick. Note where it stops rising altogether and that's your compression PSI.
Throttle open wide, or just remove the carb. Reeds must remain in place.
Kicking will cause the pressure gauge indicator to rise a little less with each kick. Note where it stops rising altogether and that's your compression PSI.
Wheelman-111
Most of my money is spent on scooterparts. The rest is just wasted.
"ISO": '03 Vespa ET4 Malossi187 74MPH
Flash 9: 2001 Elite SR Contesta 72 ZX Tran, 9:1 Gears, Stock Airbox/Carb/Pipe 58.8 MPH
Punkin: 2010 Vespa/Malossi S78, 61MPH
Most of my money is spent on scooterparts. The rest is just wasted.
"ISO": '03 Vespa ET4 Malossi187 74MPH
Flash 9: 2001 Elite SR Contesta 72 ZX Tran, 9:1 Gears, Stock Airbox/Carb/Pipe 58.8 MPH
Punkin: 2010 Vespa/Malossi S78, 61MPH
-
birdman3131
- Noob

- Posts: 4
- Joined: Wed Nov 14, 2012 9:36 am
- Location: Arkansas
Re: 1994 Honda elite SR won't start.
well s***. im only getting 35psi. also found that the piston had apperently hit the spark plug. how much is a new piston and where should i get one?
Re: 1994 Honda elite SR won't start.
greetings
Powersportsplus.com has the stock piston if that's what you want. or you can go bbk you should check the cylinder for scores and replace the rings while you're at it. Find out why the plug hit the piston. Maybe the wrong plug was used?
Powersportsplus.com has the stock piston if that's what you want. or you can go bbk you should check the cylinder for scores and replace the rings while you're at it. Find out why the plug hit the piston. Maybe the wrong plug was used?
-
birdman3131
- Noob

- Posts: 4
- Joined: Wed Nov 14, 2012 9:36 am
- Location: Arkansas
Re: 1994 Honda elite SR won't start.
Well I am back. I put in the proper sparkplug and it started right up and I have been running it. Give me a couple weeks and I may look into a few performance upgrades.