Spree Engine Swap: Honda Elite CH80 onto Spree

[Tyler VR]

I put the side plastics on from my nh125 spree with a cutout around the carb. I have another set of plastics I'm planning on modding to fit around the carb.

[Tyler VR]

Blasted the rust and old paint off my spare set of rims. I'm going to primer them now, then mount my new tires.

[Tyler VR]

Got the front fender fitted, should work out good.

I'm at the point with this project where I would like to wrap it up soon, so finishing the fitting of body plastics is my current goal. Once that's done I'm going to strip everything down and do some paint work.

[Tyler VR]

Installed my handle bar end mirrors, might try them flipped around later.

[Tyler VR]

[Kevinstonge]

Looking good! IMO with a black frame that thing would look great half naked like that!

[Tyler VR]

Looking good! IMO with a black frame that thing would look great half naked like that!

Thanks! I've been planning the color scheme, it will be all black with some gold accents/parts.

[Tyler VR]

Here's the side plastics I'm going to use and end up painting. Someone put all these sweet stickers on that I'm going to peel off.

[Tyler VR]

I bubbled out the plastic around the carb, might need a little filler work to smooth it out.

[Wheelman-111]

Greetings:

Heat gun, right? I experimented with some scrap Aero plastic to determine if it was feasible. Glad to see someone made it work. Can you show a bigger-picture shot of the outcome?

[Tyler VR]

Greetings:

Heat gun, right? I experimented with some scrap Aero plastic to determine if it was feasible. Glad to see someone made it work. Can you show a bigger-picture shot of the outcome?

Yeah I just used a heat gun and took my time, no other pics right now.

To shape the bubble in the plastic out I used a screw driver handle thats rounded and smooth on the end. You don't want to use anything with sharpe edges. It was a process of heating it up, getting the shape I want then cooling for 10mins while holding the shape. It took about 5-6 rounds of that, stretching the plastic out a little at a time.

[patthesoundguy]

I bubbled out the plastic around the carb, might need a little filler work to smooth it out.

Wow looks like it came from the factory like that

Sent from my Nexus 7 using Tapatalk 2

[Tyler VR]

Wow looks like it came from the factory like that

Sent from my Nexus 7 using Tapatalk 2

Thanks, Once I smooth it out with some filler and sanding it should look great.

[Tyler VR]

I have this turn signal rack that someone cut off the pipe that hold the signal. I always wanted to fix it, making the signals not stick out as far.

[Tyler VR]

Shorty turn signal rack.