Scratched cylinder wall

roadcapDen · Post by **roadcapDen** » Wed Jul 26, 2006 8:11 am

What say the group.

Re bore/hone?
New cylinder?
Big bore kit? If so which one?

Thanx...

MySpree · Post by **MySpree** » Wed Jul 26, 2006 1:25 pm

whadda u have?

roadcapDen · Post by **roadcapDen** » Wed Jul 26, 2006 2:32 pm

I have a small scratch from the top of the cylinder to just below the exhaust port

MySpree · Post by **MySpree** » Wed Jul 26, 2006 5:01 pm

what moped!

Post by **noiseguy** » Wed Jul 26, 2006 11:20 pm

Spree.

Contact Greg at uspmale@yahoo.com to see if he has a matched set of jug/pistons. Otherwise a factory parts overbore will run about $100.

roadcapDen · Post by **roadcapDen** » Thu Jul 27, 2006 8:12 am

Thanks Noiseguy

Umm, this is a Spree site, so, it's on my Spree...

I can get it bored 1 over for $60 + new piston and rings all together is about $110 CDN

MySpree · Post by **MySpree** » Thu Jul 27, 2006 12:16 pm

no this a a spree and elite forum. you might have had an elite or aero. smart one.

Farfignugin · Post by **Farfignugin** » Thu Jul 27, 2006 9:54 pm

or by the look of his sig, a spree and a vespa...

mixedbreed · Post by **mixedbreed** » Sat Jul 29, 2006 6:24 pm

Hey man where are you getting the work done? Most shops in Toronto won't touch the spree with a stick except cycle 109 and scooters on front I need to find a decent place to check out the spree dunno what's wrong with it.

roadcapDen · Post by **roadcapDen** » Mon Jul 31, 2006 1:28 pm

Tripps Cycle in Oakville is doing the 1 over bore, and then I'll put 'er back together myself. Ordered parts from Burlington Cycle and Sturgess in hamilton.