Variator nut size Aero 50

ck_ni · Post by **ck_ni** » Mon Apr 04, 2016 2:59 am

Hi guys,
What is the variator nut size on a Honda aero 50 (1986), the one that goes on the end of the crank, that holds on the starter driven gear etc?

Also anything specific about it, fine thread or anything like that?

Thanks

vintagegarage · Post by **vintagegarage** » Mon Apr 04, 2016 9:17 am

http://www.babbittsonline.com/oemparts/ ... drive-face

Looks like 10 mm, please look at the link above

ck_ni · Post by **ck_ni** » Mon Apr 04, 2016 9:21 am

Does look like a M10... Anyone know if its fine pitch, or just standard thread?

benji · Post by **benji** » Mon Apr 04, 2016 3:42 pm

I beleive it's "machine" thread- finer than fine pitch.

benji · Post by **benji** » Mon Apr 04, 2016 3:43 pm

Been awhile since I've had mine off tho

ck_ni · Post by **ck_ni** » Mon Apr 04, 2016 4:45 pm

Tried a standard M10,too course.
Can get an M10 x 1 or M10 x 1.25...

benji · Post by **benji** » Mon Apr 04, 2016 5:53 pm

I think it's 10x1.50mm

Honda Spree and Elite 50 Forums

Variator nut size Aero 50

Variator nut size Aero 50

Re: Variator nut size Aero 50

Re: Variator nut size Aero 50

Re: Variator nut size Aero 50

Re: Variator nut size Aero 50

Re: Variator nut size Aero 50

Re: Variator nut size Aero 50