Electric choke install ??

86gyro · Post by **86gyro** » Wed Apr 06, 2005 12:33 pm

Installing choke the correct way after cleaning. Does the brass needle go in carb first, followed by brass barrel, installed on by-stater, or does needle go in barrel frist, then in carb.

Post by **noiseguy** » Wed Apr 06, 2005 12:47 pm

You have a Gyro? The carb may be different than the Spree.

If not, follow the manual. The choke should be in one piece, so I'm not following you.

86gyro · Post by **86gyro** » Wed Apr 06, 2005 6:56 pm

I have no manual. But what ive read is that Spree and gyro by-starter are the same, so what is the correct install, needle first in carb than followed by brass barrel snap on by-starter, or needle installed in barrel than both installed in card as one piece. If neddle goes in barrel, and then barrel snaps on by-starter, I guess that would be one piece