JETS!!

windycity85 · Post by **windycity85** » Wed Mar 28, 2007 12:42 pm

Ok I dont know too much about jets even after reading this site. I get the general idea of them and whatnot but as for actual sizes i might need some help.

Basically I am going to be running the engine with ported intake and exhaust ports, gutted muffler, head milled to .015, and debating pod filters but i doubt it.

I have never changed the jet to begin with but i assume i might have to after all of this. I need to order new rings from honda today, should i order a few jets to play around with? which sizes? how much do they usually run?

thanks in advance!!

also, would it be ok to completely remove the baffles from the exhaust or would that not do much more than just drilling holes?

Post by **noiseguy** » Wed Mar 28, 2007 7:53 pm

I'd remove the baffles.

You don't need to rejet unless you change the air filter to a pod. IMHO not worth it from a performance standpoint.

windycity85 · Post by **windycity85** » Thu Mar 29, 2007 11:30 am

Im guessing I should be prepared for an un-godly sound coming from a baffle-less muffler?

ahh whatever Im doing it!

thanks for the info!