1986 Spree Carb. assembly

MichiganEd · Post by **MichiganEd** » Thu Apr 05, 2007 6:51 pm

I was wondering if it makes any difference where you line up the holes in the brass tube under the jet in the carb. I took it all apart and cleaned it and blew everything out with air hose and this tube blew out. It is about 1 inch long with all these tiny holes in it...........there two sides oposite each other with 2 holes and then 2 sides with 3 holes oposite each other. Does it make a difference where I aligin these holes when installing this tube back into the carb?.......... thanks, Ed

myhonda · Post by **myhonda** » Fri Apr 06, 2007 9:44 am

http://www.hondaspree.net/phpBB2/viewtopic.php?t=999 u mean 1986 i think so heres the 86 manual.

MichiganEd · Post by **MichiganEd** » Fri Apr 06, 2007 12:02 pm

no help there!!!...........I have the complete manual.

MySpree · Post by **MySpree** » Fri Apr 06, 2007 1:47 pm

no doesnt matter.

MichiganEd · Post by **MichiganEd** » Fri Apr 06, 2007 2:07 pm

ok, thanks......