bost bottle

Does your Spree/Elite already run great, and you're trying to make it quicker/faster? Need a monster motor swap? Discuss your ideas here.

Moderator: Moderator

Post Reply
User avatar
diomike
Spree
Spree
Posts: 219
Joined: Mon Jul 23, 1973 10:24 am
Location: Mtl,Can

bost bottle

Post by diomike »

wat do u guys think about the bost bottle alot of people down here use them on ther zumas and jogs but , i got a dio :) i herd u can make one out of a 100ml bottle..
User avatar
jeremydde
Goped
Goped
Posts: 66
Joined: Thu Jun 14, 2007 1:17 am
Location: Vancouver

Boost Bottle

Post by jeremydde »

I too am curious about installing a boost bottle. Also thinking of upgrading carbs and intake manifolds as well. Keoni at VT Cycles was telling me the other day that the 28mm carb makes the most power on the Dio's and there is an extra port on a few aftermarket intake manifolds for a boost bottle as well.
2000 Honda Dio
Malossi 72cc Bore
28mm Oko Carb 45 Pilot & 132 Main
Phongeer Long
9 to 1 Gears
Parmakit Variator
1500 RPM contra spring
Kuka Clutch w/Polini green springs
Koso Digital Tachometer w/CHT
User avatar
diomike
Spree
Spree
Posts: 219
Joined: Mon Jul 23, 1973 10:24 am
Location: Mtl,Can

Post by diomike »

iam almost done my 97 dio i got

70cc athena
8to1 gears
keli pully
ct manifold(crome)
oko 24 mm carb
center spring (blue 1200)
cluch sprigs (yellow)
tecnicgas pipe (crome)
i think thats it...
User avatar
jeremydde
Goped
Goped
Posts: 66
Joined: Thu Jun 14, 2007 1:17 am
Location: Vancouver

Carb

Post by jeremydde »

Did you happen to run your cylinder with the stock carb before you upgraded? If so was there a noticeable difference in power after the carb upgrade? I ordered 9 to 1 gears from VT Cycles as I was already able to do 85 - 90km/h with stock gears at around 9200rpm. This was confirmed with a car driving beside me. I am a little wary of going much faster as the brakes are insufficient as it is. I upgraded the rear tire to a 90/90-10 and noticed a difference in grip and braking and I recommend you do the same. I picked up some Pirelli tires for $38 a piece and am very satisfied with them.
2000 Honda Dio
Malossi 72cc Bore
28mm Oko Carb 45 Pilot & 132 Main
Phongeer Long
9 to 1 Gears
Parmakit Variator
1500 RPM contra spring
Kuka Clutch w/Polini green springs
Koso Digital Tachometer w/CHT
User avatar
diomike
Spree
Spree
Posts: 219
Joined: Mon Jul 23, 1973 10:24 am
Location: Mtl,Can

Post by diomike »

mine didnt run nice with a stock carb. the carb make it alot louder too and helps with power and i already got the same size tire .i got to say one thing gears help ALOT d***. i was also wondering if u now any ways to keep the engine cooler..?> anpther question do u premix?
User avatar
jeremydde
Goped
Goped
Posts: 66
Joined: Thu Jun 14, 2007 1:17 am
Location: Vancouver

Post by jeremydde »

My engine never gets any hotter the 110 degrees celcius even yesterday when it was 39 degrees celcius outside. I have a CHT sensor installed. This is with an 85 jet with the stock carb as well. I don't premix, I am still running the factory oiler. On average my temps are in the 95-99 degree range. They sell a ram air scoop for the fan that should aid in cooling but I have not purchased one as of yet. From what I've been told I can run the motor hotter that I currently am safely so I haven't really been trying to cool it more. My stock carb wouldn't run the motor well either even with the 85 jet until I raised up the needle 2 clips, then the engine smoothed right out.
2000 Honda Dio
Malossi 72cc Bore
28mm Oko Carb 45 Pilot & 132 Main
Phongeer Long
9 to 1 Gears
Parmakit Variator
1500 RPM contra spring
Kuka Clutch w/Polini green springs
Koso Digital Tachometer w/CHT
User avatar
diomike
Spree
Spree
Posts: 219
Joined: Mon Jul 23, 1973 10:24 am
Location: Mtl,Can

Post by diomike »

cool cool do u got a pik of ur bike???
User avatar
Crotchrocket
BMX
BMX
Posts: 37
Joined: Tue Jul 10, 2007 2:13 am
Location: Jasper, Indiana

Post by Crotchrocket »

See ram air post later tonight!
"CrotchRocket"

1994 Honda Elite SR-Polini 72CC Corsa kit-Polini Carbon Reeds-#100 Carb Jet-Keli Variator-1000RPM Center Clutch Spring-Ram Air Cooling-60MPH!
Post Reply