Source for 39mm socket?

Post by **noiseguy** » Tue Feb 26, 2008 11:11 am

Guys: Anyone got a good online source for the 39mm socket used on the Spree clutch? Link in Tech Docs is dead.

Thanks!

burnt_toast · Post by **burnt_toast** » Tue Feb 26, 2008 11:26 am

I got a 1-1/2in huge socket from Northern Tool a while back, this size is right about ~38mm for jog style clutches. May work for spree's too.

Good price, think it was only $5-8

Kenny_McCormic · Post by **Kenny_McCormic** » Tue Feb 26, 2008 12:01 pm

Know a mechanic? Snap-on dealer might be able to order one. Nevermind snap on only has the 38 and 40 mm ones(that and they probably cost more than a new clutch).

http://irtoolsales.com/ingersoll-rand-m ... 6m39u.html Pricey fancier than needed and in 3/4 inch drive, their cheaper standard and deep sockets only come in 38 and 40.

Craftsman doesnt make a 39.

Has somebody actually measured the nut to be 39 or what? It seems like an odd size to put on something is is in all other areas very easy to work on.

1.5 inch sockets are 38.099999999999994 millimeters.

burnt_toast · Post by **burnt_toast** » Tue Feb 26, 2008 1:58 pm

Kenny_McCormic wrote: 1.5 inch sockets are 38.099999999999994 millimeters.

I'm willing to bet would likely work on Spree clutch as well. Could never find it online, but its there instore.

Farfignugin · Post by **Farfignugin** » Tue Feb 26, 2008 2:37 pm

Found the closest you can get:

1 9/16" 12-point Socket; 3/4" Drive
Item Number from Grainger Catalog: 1AP53

Price: $29.20

There ya go...

Kenny_McCormic · Post by **Kenny_McCormic** » Tue Feb 26, 2008 2:43 pm

Farfignugin wrote:Found the closest you can get:

1 9/16" 12-point Socket; 3/4" Drive
Item Number from Grainger Catalog: 1AP53

Price: $29.20

There ya go...

Thats 39.6875mm, being standard it is incredibly easy to find and you can probably get it in 1/2 inch drive.

http://irtoolsales.com/ingersoll-rand-s ... 1-916.html ~$23 shipped ups ground, 1/2 inch drive so it fits most impact guns.

Post by **noiseguy** » Tue Feb 26, 2008 4:43 pm

39mm is the size according to the manual, and it measures the same. They are nearly impossible to find anywhere; most companies make 38mm and 40mm.

A 38mm socket will *just* fit with some forcing, but eventually it will trash the nut from spinning off. I used one for awhile and took it back (free tool rental from an auto place); wasn't pleased with how well it worked.

Good find on the 39mm Ingersoll-Rand and the 1 9/16 SAE. I'll try to run down the latter when I need one next.

uspmale · Post by **uspmale** » Tue Feb 26, 2008 8:52 pm

Any one have a line on 1000rpm clutch springs for NQ50 Spree?
Thanks, greg