Trying to get your Spree/Elite to run, or run better? Post your questions here.
Moderator: Moderator
Elite-ist
Spree
Posts: 135 Joined: Sat Dec 31, 2005 7:00 pm
Location: Portsmouth, New Hampshire
Post
by Elite-ist » Wed Jul 23, 2008 7:45 am
Where does air draw into the airbox? I see a square tube on the bottom that looks likely - it looks like everywhere else is sealed off. Is this square tube the only inlet?
Scalpel
BMX
Posts: 26 Joined: Tue Apr 29, 2008 7:53 pm
Location: Seattle, Washington
Post
by Scalpel » Wed Jul 23, 2008 1:23 pm
If it's anything like my 89 Elite, then yes, it's all the way at the back, pointing down. That way any water doesn't get in.
Elite-ist
Spree
Posts: 135 Joined: Sat Dec 31, 2005 7:00 pm
Location: Portsmouth, New Hampshire
Post
by Elite-ist » Wed Jul 23, 2008 3:36 pm
Scalpel wrote: If it's anything like my 89 Elite, then yes, it's all the way at the back, pointing down. That way any water doesn't get in.
Thanks for the reply - that's the only inlet on the box? I though I read people saying there was more than one
greenninja37
BMX
Posts: 22 Joined: Tue Jul 22, 2008 2:22 am
Location: waterford
Post
by greenninja37 » Thu Jul 24, 2008 1:33 am
well on my 84 spree and also on my part bike 85 spree yeh all ive noticed is that square intake hole, and if i remember i think it got double holes right?
New to the moped scene.
Proudly riding a White 84 Spree
maddog
CB900F
Posts: 2171 Joined: Mon Jul 23, 1973 10:24 am
Post
by maddog » Thu Jul 24, 2008 3:15 am
on the elite-s one side is plugged just cut it out and do the correct derestrictions at the same time.
some people dream of speed, i own your dreams!