I DONT WANT TO DIE ON A SPREE

timcat · Post by **timcat** » Tue Dec 16, 2008 2:40 am

i have an iowa spree what can be done with in reason to make it go about 30 or 35 it goes like 22 l Evil or Very Mad i live in flint so im not likely to get pulled over for any broken moped laws and id rather not get ran over and live any way so i have read about the .5 in belt what if its not coged my jet is a 65 i belive had it out was looking at it earyler and i was riding it today starts no ether needed starts every time and it takes off fast but when i hit mid range on the throttle it goes smooth up to 22 23 mph any more gas it bogs out wont stall just runs sluggish although im perplexed that when the air screw is all the way in it dont stall out rite away Question

Bear45-70 · Post by **Bear45-70** » Tue Dec 16, 2008 4:17 am

Your engine is running too lean.

timcat · Post by **timcat** » Tue Dec 16, 2008 4:21 am

how do i fix this

Bear45-70 · Post by **Bear45-70** » Tue Dec 16, 2008 5:20 am

Like I told you elsewhere. Check float level and repair as necessary and/or clean the carb making sure all the little holes and passages are clear. Then if it is still doing it, do a plug chop (I hate that term as your aren't chopping the plug at all) and check you mixture. For carb adjustments look in the tech section for the manual.

Next time don't post the same question 3 different places.

burnt_toast · Post by **burnt_toast** » Tue Dec 16, 2008 7:48 am

As noted, no reposting needed, and be clear in asking your question for best advice