Honda Spree and Elite 50 Forums

so, sum-azn-kid says the scorpion is real loud, i've found pipe sound levels to be very subject myself, any one have a vid with this pipe in use ?

wheelman-111 how loud is that "hot surface" pipe ? is that or something VERY similar to it readily available ?

i'm looking for a pipe that will heavily boost the off idle to 8-9k rpm range.

thanks,
steve

Greetings:

The Hot Surface pipe is a bit louder than stock, comparable to the intake noise of an open Pod. Much quieter than the PG and the Chamber pipes with muffler add-ons I've owned. Taz sold me mine, might have more. It's very good on the low end, seems to rev out to about 8-9K.

Taz what say you? Can you give us some more details on this pipe?

Thanks,

Nathan

Would be interested in more info on buying one of these hot surfaces jawns.

yes, seems to be a common interest, though Taz seems to be keeping quite about the whole thing. too bad, i'd be in for sure.

steve

If you're building a BB non stroker, I would use #2, V8 copy. But if you want the best, Scorpion is second to none if tuned right and not as loud.

Munstah666 wrote:If you're building a BB non stroker, I would use #2, V8 copy. But if you want the best, Scorpion is second to none if tuned right and not as loud.

Why a v8 copy? Why not just get an actual v8?

eliteguy50 wrote:

Munstah666 wrote:If you're building a BB non stroker, I would use #2, V8 copy. But if you want the best, Scorpion is second to none if tuned right and not as loud.

Why a v8 copy? Why not just get an actual v8?

I was merely referring to which ones in HIS LIST (pg 1) I would use, but if you ask me LOOK at the second part of my qoute. ^^^

Munstah666 wrote:... I was merely referring to which ones in HIS LIST (pg 1) I would use...

Oh, I wasn't sure if one had better welds or metal or what.