Keeping Spree Elite Aero 50cc and Gyro Alive!
http://hondaspree.net/hondaspree.net/phpBB3/
http://hondaspree.net/hondaspree.net/phpBB3/viewtopic.php?t=20017
Wheelman-111 wrote:Greetings:
Suddenly TrafficJamz = Buzzkill!
The front engine would make a hellova Dio starter.
the clutch pads swing around at about 4,000 rpms, and hits the carb. the front pulley is from a go kart, and it's welded on. it goes 80.Trafficjamz wrote:I hope this was meant to be a joke.
There is no way this piece of $hit runs or moves.
The front pulley is a clutch mounted backwardswith no nut to hold it in place.
The clutch pucks are just flinging around all over the place, with no bell to keep them from flying off.
benjammer112 wrote:the clutch pads swing around at about 4,000 rpms, and hits the carb. the front pulley is from a go kart, and it's welded on. it goes 80.Trafficjamz wrote:I hope this was meant to be a joke.
There is no way this piece of $hit runs or moves.
The front pulley is a clutch mounted backwards
The clutch pucks are just flinging around all over the place, with no bell to keep them from flying off.
it goes 80....I get it. 
it actually goes 10. hahaha, but that's because of the way it's geared, if i put a bigger pulley on the front i bet i could get it to go around 60 or so.Trafficjamz wrote:benjammer112 wrote:the clutch pads swing around at about 4,000 rpms, and hits the carb. the front pulley is from a go kart, and it's welded on. it goes 80.Trafficjamz wrote:I hope this was meant to be a joke.
There is no way this piece of $hit runs or moves.
The front pulley is a clutch mounted backwards
The clutch pucks are just flinging around all over the place, with no bell to keep them from flying off.
Oh so this is a joke.
Good one
10 MPH? 
