Page 2 of 4
Re: noob wondering what i have
Posted: Sun Oct 28, 2012 10:42 am
by ss421
And the jug and head are square not round if that helps at all....
Re: noob wondering what i have
Posted: Sun Oct 28, 2012 11:10 am
by eliteguy50
Measuring the crank shaft diameter would be undeniable proof as to which engine you have.
Re: noob wondering what i have
Posted: Sun Oct 28, 2012 11:15 am
by ss421
Ok so i measure from where to where????
Re: noob wondering what i have
Posted: Sun Oct 28, 2012 11:42 am
by eliteguy50
Remove the kickstart cover. The front shaft that the belt goes around is your crankshaft. Measure the diameter of the end of the shaft.
Re: noob wondering what i have
Posted: Sun Oct 28, 2012 12:17 pm
by Wheelman-111
Greetings:
Don't overthink this, Dawgs. Yes some Japanese AF05s came with the split belt cover, but otherwise the most visible distinction is the exhaust flange. If it points straight ahead, it's a SA/16. If it angles to the right, it's a SE/05. Evidently your engine's been modified extensively either way, but unlikely the P.O. Could get swap a cylinder from one to the other. Bolt spacing is different.
Re: noob wondering what i have
Posted: Sun Oct 28, 2012 1:15 pm
by ss421
Do i have to remove the starter sproket ???
And yes there is a bolt on the back part of the kick start cover...and i don't think that is stock airbox upon removal it was held on by zip ties
Re: noob wondering what i have
Posted: Sun Oct 28, 2012 1:16 pm
by ss421
.
Re: noob wondering what i have
Posted: Sun Oct 28, 2012 1:28 pm
by ss421
If i can do it like as if i was taking of a power steering pump off a car and wrapping string around it and measuring the string it is 2 1/2 inchs... hope that helps if not just let me know
Re: noob wondering what i have
Posted: Sun Oct 28, 2012 1:34 pm
by ss421
.
Re: noob wondering what i have
Posted: Sun Oct 28, 2012 3:20 pm
by LMH
Neat you have an arrow pipe for an af05e, I also didn't know they had split covers for the kicker on some.
Re: noob wondering what i have
Posted: Sun Oct 28, 2012 3:26 pm
by Wheelman-111
Greetings:
It's curious that the previous owner of a 1995 SA50 went against Common Wisdom:
Dude! He swapped OUT the Dio!!
Re: noob wondering what i have
Posted: Sun Oct 28, 2012 3:30 pm
by eliteguy50
Imported af05 explains the pipe.
Re: noob wondering what i have
Posted: Sun Oct 28, 2012 4:00 pm
by ss421
The crank shaft diameter is 2 1/2
Re: noob wondering what i have
Posted: Sun Oct 28, 2012 4:14 pm
by eliteguy50
That is the circumference, the diameter is the distance straight across the shaft at its widest point:
http://www.beevo.com/images/Measure%20W ... ameter.jpg
Re: noob wondering what i have
Posted: Sun Oct 28, 2012 4:16 pm
by eliteguy50
I need to check my math because I get a 20mm diameter from a 2.5" circumference.
