Page 2 of 3
Posted: Wed Jun 28, 2006 1:53 pm
by Farfignugin
so where can u get this "seafoam" stuff, and about how much does it go for?
Posted: Wed Jun 28, 2006 3:47 pm
by kurremkarm
I got mine at an autozone it was like 5 bucks.
Posted: Wed Jun 28, 2006 4:37 pm
by jbarb
Ive heard nothing but good things about this stuff. I might have to try it.
Posted: Wed Jun 28, 2006 7:55 pm
by MySpree
yea, also if u take it apart u can find that maby the carb was clean, but a part was broken or not there, or maby just not set right.
Posted: Wed Jun 28, 2006 9:15 pm
by Farfignugin
yes but by taking it apart u could have caused that part to break or fall onto a floor and never find it again.................
Posted: Wed Jun 28, 2006 9:33 pm
by MySpree
well if u break a carb apart trying to vlean it then they should have opayed someone to do it.
Posted: Thu Jun 29, 2006 8:50 am
by Farfignugin
what if it was one of those "accidents" even those mechanics can do that....
Posted: Thu Jun 29, 2006 10:30 am
by mopedman
you all are soooo dumb why dose everyone argue about every thing in every post, the guy that put up this post was trying to be helpfull, i am going to try it and see if it works good and if it dose i am going to put it in tec docs
Posted: Thu Jun 29, 2006 10:33 am
by Plooster
mopedman wrote:you all are soooo dumb why dose everyone argue about every thing in every post, the guy that put up this post was trying to be helpfull, i am going to try it and see if it works good and if it dose i am going to put it in tec docs
Sorry, noiseguy already put in in there almostly immediately after this thread started.
Posted: Thu Jun 29, 2006 10:35 am
by mopedman
oh ok i didn't see that
Posted: Thu Jun 29, 2006 12:15 pm
by MySpree
dude sam u are jsut trying to oceruse ur powe!!!!
Posted: Thu Jun 29, 2006 12:16 pm
by Spreewell
I did it a couple more times and now my Spree is going 50MPH! This is the best.
Posted: Thu Jun 29, 2006 12:19 pm
by MySpree
ok ur a liar and my eltie goers 50! cuz its MODIFYED!
Posted: Thu Jun 29, 2006 1:12 pm
by Plooster
Hey Myspree, I sent you a PM.
Thanks
Posted: Thu Jun 29, 2006 6:18 pm
by mikeb
ummm, i'm guessing the reason you are running faster is because you are decarbonizing your head when you run that stuff. same effect as misting water into a carb, except it's safer.
sure it probably cleans the carb too, but seriously, how lazy can you be not to just take the carb off and spend seven minutes cleaning the thing. then you can use compressed air and be sure that everything is clean and then inspect it too.
btw - i don't like the stuff. i call it headgasket eater cause it cleans out so many deposits in cars that it leaves holes where deposits used to be. on a moped it probably doesn't matter as much though - so go nuts.