Honda Spree and Elite 50 Forums

pics

Nice clean up, the ct can use a lot of porting on the down turn.

Match up that little triangle in the port with the other side .Is this a stroker ? Them some big ports .

LoveMyHonda wrote:Nice clean up, the ct can use a lot of porting on the down turn.

Yes Sir

paulpauly7 wrote:Match up that little triangle in the port with the other side .Is this a stroker ? Them some big ports .

Match where?pics please
No
Malossi mhr high speed bearings
Malossi crank
AIO crankcase job


Im just starting on my AF16 project

top left in your first pic and bottom right in your second pic .where the base gasket sits the looking down into the cases the port windows have sharp corners stator side is open intake side is half blocked.

paulpauly7 wrote:top left in your first pic and bottom right in your second pic .where the base gasket sits the looking down into the cases the port windows have sharp corners stator side is open intake side is half blocked.

Got it,thanks, im going to match all when i get the cylinder kit and started to work on it.

What cylinder kit do you plan on running? Your port job is looking top notch very clean ct. But like Pauly said make sure you smooth out that little triangle will cause a lot of blockage for air and fuel movement.

curtis966 wrote:What cylinder kit do you plan on running? Your port job is looking top notch very clean ct. But like Pauly said make sure you smooth out that little triangle will cause a lot of blockage for air and fuel movement.

Got it,thanks,like i said im just started
When i get the cylinder kit im going to see what i get and what i
have to do

working on the crankcase,one step less

What is that stuff?

is that J-B weld original?

chamisataza wrote:is that J-B weld original?

Is a two parts marine epoxy + high temp fiber glass fabric
used for 2 stroke engine on
stand up jetski

Jbweld dont work with gas n oil

graphite9 wrote:wow, you put time into that. Kudos.

No much ,just few min a week,i don't have the time to spend on this hobby like a want to.

Hi AIO. Do you have a name for that stuff?
what are you building? 72cc?