Honda Spree and Elite 50 Forums

scootfast wrote:Ped hope you don't use that v8 pipe. That pipe cost me a motor just ask G9. Just a heads up. The exhaust is not the place to save money. Not saying you are just letting you know. Jim P.S. how did those parts work out for you that I sent.

Hi jim. thanks, the pipe should be good. I'm only going 50mm, up to 90ish cc's.
pm sent.

72cc

Corsa/44.4 ministroke

It's an af16e fabrizi/mhr build this time. More expensive cousin of the zx50 fabrizi/mhr.



Af16e wheelman ported, unported 50mm fabrizi racing cylinder, malossi rhq crank, well ported ct chrome intake, v force 3 reeds, polini 26mm carb, polini large air filter, light weight flywheel, polini for ruckus vario, 3.2g polini racing rollers, .5mm shim, ncy drive face, dio zx malossi belt, ncy racing rear pulley set on quick action, malossi yellow contra spring, polini 3 shoe with yellow springs, malossi wing bell, 7.58:1 final gears, kn planning rear brake arm, and malossi brake pads.
Basically near the same as the zxspree build.

125cc

hey 1man where did you get that wing that looks awesome. wasnt sure till I saw it on your bike

The wing seller is super secret and I couldn't ever tell you da808nanospeed sold them a while back.

To generic.

maddog wrote:To generic.

Too lame.

Greetings:

That wing is the coolest accessory I've seen in a long time!

Wheelman-111 wrote:Greetings:

That wing is the coolest accessory I've seen in a long time!

I likie it too.

Lame is as lame posts

Maddog asked me to post a picture he emailed me of his newest fully modified ride.


Sorry ped he begged me to a million times.

Woof! Woof!