Honda Spree and Elite 50 Forums

Got my tailight in today and i'm kinda stump. haven't pulled it apart yet. But where do the to studs mount on the bike and what nuts do i used to attach them? The one i got is exactly like th one above but with clear lenses. And can i use those male quick disconnects to attach the wire? Or is that going to cause problems down the road? Again where do the nuts come from to attach it. They already on the bike or what. It came with no hardware.

everthing must be remove! gas tank,seatbucket, Both side panels/skirts

rear tail goes into.



close up picture!


Yes, you use same wire goes to tail and turn signals, need to cut and spice wires and plug it.

Thanks for the help! I just started tearing it apart and relized i don't have any quick disconnects or solder.