Honda Spree and Elite 50 Forums

Thanx seanzee...manuals also contained here in WikiSpreedia..... ...Plus I have hard copy...Gyro S imported '85 &'86.... Majourlittle: Several would benefit from a schematic for Gyro rear wheel adapters. First dimension needed is the bolt pattern/diameter of Gyro S hubs....then the same for the wheels intended for replacing stocks. I can provide stock measurements, but no idea what wheels I would use to replace stocks....most likely an 8" with 4-lug on 4" dia.....( NOT buying wheels from Japan for $200 each)...spacing will also be at issue so adapter thickneess is critical to wheel choice. A basic schematic could be created and then revised for alternate wheel choices. Thanx for any drawings you can provide.........

Lets do it then.

Need diameter of the bolt hole. need diameter of the center hole and need the inside-to-inside measurement of one bolt hole to the center hole.

PM me if you want to get this sorted.

That is not my trike,sorry if that was the impression taken,was not my intent.I am working on a Lifan based trike and those are images that I have collected for ideas. The page that I posted has adapters to do that and there is a a guy on Ruckus .com that is working with different ones than stock. It is a simple matter to make a new plate for any existing rim with the proper spacing and offset.Russ

look at what this guy did !!! and look at his other vid ..
swimmingfree

http://www.youtube.com/watch?feature=pl ... bsMWvhihAs

:3