Honda Spree and Elite 50 Forums

Posted: **Tue Sep 13, 2005 3:49 pm**

i forgot to ask if anyone could post a pic of wut it should look like thx

Posted: **Wed Sep 14, 2005 7:49 pm**

do you have to take the clutch apart to get at the pully?????

Posted: **Wed Sep 14, 2005 7:50 pm**

no. its not on the clutch its on the crankshaft.

Posted: **Wed Sep 14, 2005 8:03 pm**

so wut would i have to take off in order to get at the pully

Posted: **Wed Sep 14, 2005 9:33 pm**

crankcase cover and the nut holding the pulley on.

Posted: **Thu Sep 15, 2005 1:32 am**

This is all explained in the technical section. But I'll say thi anyways. The washers are used to re-align the pully halves so the belt rides straight. If you dont re-align the pully you will go through belts faster than normal.

You also can use the washers to adujst the spacing between the pully halvs to set how much top end low end you want.

Posted: **Thu Sep 15, 2005 3:54 pm**

did u find it hard to do??

Posted: **Fri Sep 16, 2005 8:23 pm**

NO

It was extreamly easy. I did it after smoking a huge joint. and even then it was easy

Posted: **Fri Sep 16, 2005 8:32 pm**

Posted: **Fri Sep 16, 2005 8:43 pm**

did you find the acceleration alot slower

Posted: **Fri Sep 16, 2005 9:22 pm**

YES

But that can be corrected.

Posted: **Fri Sep 16, 2005 10:16 pm**

how???

Posted: **Sat Sep 17, 2005 2:20 pm**

Clutch Springs

And to answer you next question..................Read through the forums

[/b]

Posted: **Sat Sep 17, 2005 3:48 pm**

Quick question.

I am gonna do this mod, but I do not want to take off the belt to bring it in for the oversized one. I have an 86 Spree, has anyone done this mod and what belt did you buy? Part # / Brand would be great. Thanks.

EDIT: I already took mine off and did the mod. I went from 27mph to 30-31mph top end. Bottom end is a bit less torquey...but no too bad.

Posted: **Sat Sep 17, 2005 5:26 pm**

alright thx alot i have no more questions about this

Honda Spree and Elite 50 Forums

Pulley mod: 84/85 vs. 86/87 Spree