Honda Spree and Elite 50 Forums

Gutted the cage and port matched it to the intake, I also took a little off the part hanging down because it blocked about a quarter of the ports going to the cylinder.

Inside view.

Sealed up nice.


I highly recommend doing this. Its super easy, just need a hack saw blade, some files, and sand paper.

Ordered my cable and oil plug! Maybe this time next week I can be driving this thing.

Picking up my BBK in half an hour. MIGHT even have enough for an SP3, even though I would rather a V8 but I don't want to go through the trouble of having it chopped and welded.

BBK On. HEAT SHROUD ON. New throttle cable installed. Waiting on my jets and oil pump plug to arrive. Also ordered a Trail Tech temp gauge to keep an eye on my CHT. REALLY cant wait to fire this thing up. Even if it is just to heat cycle it a few hundred times.

Where did you get your jets from?

I got a set of pilot jets from ADA Racing, and I got a set of main jets from ebay, which are taking FOREVER to get here.

Jets-r-us took 2 days! Not the cheapest but the fastest I've seen. jetsrus.com also has fuel hose, carb rebuild kits and filters. Check them out!

I got 10 jets for $10 from ebay. And it included all the ones I needed. I scored on that one.

How much was the overseas shipping?

$3 shipping from Ohio

My bad it was 12 jets LOL

Hope you get them and if you could give us the site? We all like good deals! Thanks Justyn

The guy I got the main jets from was weaverperformance on ebay. He doesnt really have much for sale right now but later on, who knows. The slow jets were from www.adaracing.com

Decided to bolt my engine back on the Elite. You get a few funny looks when you walk around downtown with a whole engine and wheel. Still waiting on my oil pump plug and main jets to arrive. Should be tomorrow, then I can start heat cycling it.

She lives!! I got it to kick over and warmed it up. Gonna do that a few times today and maybe scoot around the parking lot a little this evening.