Page 7 of 7
Posted: Thu Dec 22, 2005 5:04 pm
by diosoljah
My ped is down for the count! Rear pulley broke the welds right off the spindle!
Posted: Thu Dec 22, 2005 5:12 pm
by darat
how in helll did u do that
Posted: Thu Dec 22, 2005 7:03 pm
by maddog
thats strange, i can't see any welds on the rear pulley? vt cycles sells them cheap.
Posted: Fri Dec 23, 2005 2:10 pm
by diosoljah
Okay, its the rear Pulley, where the clutch and torque driver sits on, Ill post pics later, oh by the way, It was the first test run since increasing the compression from 115 to 135 psi. My speed when It broke was near 50-60mph. I was like DANG, MuthaF#@ker, Had to push for about 2 miles. just got a whole new tranny setup, The ZX Tranny set up, Higher rear Pulley, adjustable torque driver, and get this a centerspring bearing to reduce drag and friction of the center spring oh and the belt is wider too.
Posted: Sat Dec 24, 2005 3:53 pm
by diosoljah
started a new thread in performance technical about the ZX tranny coversion