Page 1 of 1
Custom Switch Placement... Where?
Posted: Fri Sep 02, 2005 3:19 pm
by Justinsane
hey all, im hookin up so neons to my spree, im gonna drill a hole a little smaller than a dime somewhere... but im having a hard time finding a place to do it? So far i think im gonna have to rig it into the ferring..
any suggestions?
Posted: Fri Sep 02, 2005 4:17 pm
by vette76
under ign. that way the back will be hidden behind horn cover.
switch placement
Posted: Tue Sep 27, 2005 11:09 pm
by MacgyveR
if it was me i'd intstall a little round swtich in the seat lock whole in the back panel because you dont need to unlock it with a key to open it just push underneath back of seat and lift. i never use key takes to long.
switch placement
Posted: Tue Sep 27, 2005 11:09 pm
by MacgyveR
if it was me i'd intstall a little round swtich in the seat lock whole in the back panel because you dont need to unlock it with a key to open it just push underneath back of seat and lift. i never use key takes to long.
Posted: Tue Sep 27, 2005 11:32 pm
by Justinsane
yeah it sure does..
Posted: Tue Sep 27, 2005 11:32 pm
by Justinsane
yeah it sure does..
Posted: Wed Sep 28, 2005 9:08 am
by darat
just mount it by the Ignition
Posted: Wed Sep 28, 2005 4:44 pm
by Justinsane
i already mounted it weeks ago, i put it on the fuel petcock cover.. looks nice
Posted: Thu Sep 29, 2005 4:38 pm
by MaskedJellybean
Couldn't you also put it underneath the seat? Not too convenient, but then you don't have to drill any holes.