clutch limiter?
Posted: Fri Jul 31, 2009 1:40 pm
Does a 1986 honda spree have a clutch limiter on them? If so how easy is it to remove?
There is not a restriction on the pulley. Sprees do not have a variable belt transmissions like the Elite SE/SA50's and Aero50's, thus no need to restrict some models.
Some owners use a wider belt, to make the belt ride higher on the pulley.
http://www.hondaspree.net/phpBB3/viewto ... ree#p61198
But ask around, I don't recall *how much* speed is gained from that change. Might be just something you'd pick up if already needed a belt.
If you have not looked at 'keithw's thread on speeding up an '85 Spree, its good reference to look at.
http://www.hondaspree.net/phpBB3/viewto ... f=4&t=6510
Basically Sprees were built to be moped speed (30ish), and for Iowa, slower(25). But the '86/'87 is faster than the '84/'85. If you have an Iowa model you can check for a restricting washer in the muffler at the cylinder end. A true non-Iowa Spree also has a different gear ratio in the trans good for about 10%, and a cylinder with different port timing.