Page 1 of 1
80cc Taiwanese big bore kit
Posted: Wed Sep 16, 2009 11:56 am
by nacree
http://cgi.ebay.com/ebaymotors/Honda-DI ... 06.c0.m245
Any opinions on this kit? Just got a '99 SR- I'm pretty impressed by the bike stock but will want more power soon.
Thanks,
Nathan
Re: 80cc Taiwanese big bore kit
Posted: Thu Sep 17, 2009 2:22 am
by veedubh20
forget about 80cc bore kit, need to open block apart and port job required.
Just get a polini contesta bore 72cc is very good street bore kit. I have over 5,500 mile on that polini bore kit and was properly tunes.
Re: 80cc Taiwanese big bore kit
Posted: Thu Sep 17, 2009 9:00 pm
by maddog
i hope you mean speed not power? all you need to get is a set of 9:1:1 gears , bump up the center spring & clutch springs & #85 main jet = 54mph
Re: 80cc Taiwanese big bore kit
Posted: Mon Sep 28, 2009 4:27 pm
by tazland001
i sell a 90cc bolt on for the elite s,sr. No engine mods required.Only need to re-jet stock carb. I also have gear ratios for the elite s.
Marc
Re: 80cc Taiwanese big bore kit
Posted: Mon Sep 28, 2009 10:46 pm
by bradthreee
For $50 more bones go with the Polini if you want a big bore kit. Maddog tell him tiawanese junk go boom
Re: 80cc Taiwanese big bore kit
Posted: Sat Oct 03, 2009 10:55 am
by bakaracer
tazland001 wrote:i sell a 90cc bolt on for the elite s,sr. No engine mods required.Only need to re-jet stock carb. I also have gear ratios for the elite s.
Marc
What brand and how big is the bore in mm?
Re: 80cc Taiwanese big bore kit
Posted: Sat Oct 03, 2009 6:18 pm
by burnt_toast
tazland001 wrote:i sell a 90cc bolt on for the elite s,sr. No engine mods required.Only need to re-jet stock carb. I also have gear ratios for the elite s.
Marc
ugh yea im with baka. no such thing.
biggest on stock crank is 85cc and boost porting recommended
Re: 80cc Taiwanese big bore kit
Posted: Tue Oct 06, 2009 12:51 am
by maddog
Go run it= remember there is a dumb * born every minite on this forum
Re: 80cc Taiwanese big bore kit
Posted: Tue Oct 06, 2009 9:27 pm
by benH
maddog wrote:Go run it= remember there is a dumb * born every minite on this forum
its spelled minute, dumb *
Re: 80cc Taiwanese big bore kit
Posted: Wed Oct 07, 2009 11:28 am
by tazland001
there are bigger bolt ons than the 50mm. I have seen a 52mm bolt no mods for the dio/elite s,sr. And tawain no go boom. You have to break them in. I have installed hella 50mm kits in vegas and they last for years. In the dry heat of 115. I have tested all the major kits brand kits side by side and there is no major difference between them, except price. Hey maddog I will build a scooter to race you. I aint chicken. where you live? hehe ...hey maddog what is teeth count on your gears in the * end?
marc