Page 1 of 1
pin
Posted: Wed Sep 28, 2005 9:26 am
by Mormonmopedmaifa
alright i now have a replacement pin(the little brass one in the bystarter) on the way but will it damage my spree to ride it while i have no brass pin in there? like if i just put the bystarter in there without the brass pin soudnt it seal off air and keep it from leanin out? i know i need the new one cuase i live in colorado and its gettin cold in the mornings.
Posted: Wed Sep 28, 2005 11:22 am
by noiseguy
You'll be running constantly with the choke on, which is too rich. May overheat the engine and toast the piston or rings.
Posted: Wed Sep 28, 2005 10:15 pm
by Mormonmopedmaifa
How odea the aut-choke thing even work?(why would the choke always be on if there were no pin in there?)
Posted: Thu Sep 29, 2005 4:39 am
by noiseguy
It's not really a choke per se, it's an enrichment circuit. After the scoot is on for 30 seconds or so, the pin drops down and closes off the enrichment circuit.
Posted: Thu Sep 29, 2005 9:08 am
by Mormonmopedmaifa
so would it start better with it open like it is or would it run better with say a rivet or something in ther in place of a pin