Honda Spree and Elite 50 Forums

Will a Keihin 24mm carb work on af16 motor with the ct manifold? Is it better than an OKO flatslide? And are the jets from an OKO interchangable? I found 7 available on Ebay but listing says they are for 125-150cc.

http://cgi.ebay.com/ebaymotors/Keihin-c ... leQ5fParts

I was looking at the Mikuni's too, how are they compared to the OKO? Bad thing is, they bolt on instead of using rubber mount to ct manifold. I just want a 24mm at a decent price

How about a 26mm oko roundslide? Are roundslides not recomended? That last question for now

that Keihin is the same carb that wheelman had on flash II, that now graces the CT mani bolted to my AF16

so yes it will fit, as for being better...i dont know
i went from stock carb to the 24mm CV

A flat side is more responsive and crispier.but the round slide will work just as good.The pe24 keihin uses the same jets as the oko and keihin pwk.yes it will fit in the ct manifold.the old school setups back in the early 90's,we used the pe24 carb and alot of the companies sold that as there kit.

Thanks for the replies

Is this real? $21 for pe24....

http://www.ebay.com/itm/Keihin-PE20-PE2 ... 5d&vxp=mtr

Jet kit only, read the description for more info.

wow I feel dumb oops sorry for wasting the time!